Vehicle1Config is throwing the error. When only ECU3 is enabled no error codes but still blue screen with no camera available when putting it in reverse. Thanks for helping narrow down this far much appreciated. I also checked the cameras cables and see that power is received so not sure if DOA...
Vehicle1Config is throwing the error. When only ECU3 is enabled no error codes but still blue screen with no camera available when putting it in reverse. Thanks for helping narrow down this far much appreciated. I also checked the cameras cables and see that power is received so not sure if DOA...
I usually set both, but good point you made. I'll try setting one each and scanning for faults. Can I ask if the fault is in one and not the other what will that provide?
Reverse lights work. Bulbs were burnt out. Once replaced working as expected. The kit is just power, ground and video. When disabling the alfaobd back to NOT present the code does not appear when placing the vehicle in reverse as it would when setting it to present. When setting it back to...
Ok so after some further research I found I have an error code U0264 Lost communication with camera module. Everytime I clear this it comes right back when I rescan. Anyone know what part this refers to?
Any one else installed a Infotainment
aftermarket kit and had similar issues? I double checked the wiring and it's all correct. Also I am on the latest FW version 17.43.X so not sure if that would be of any concern. Any help would be appreciated. Thanks I'm advance.
Thanks for the help. The kit I ordered doesn't require splicing as it draws power from the 12v outlet so that's why I'm a bit perplexed on what it could be. I will be checking the connections behind the headunit to verify nothing disconnected.
It's the aftermarket system from "infotainment". Not sure but it looks like my reverse lights went out or always have been out but haven't noticed until after installing the backup camera unit. Do model year 2013s have a reverse switch or controlled via a switch under the shifter?
The truck had...
Hi everyone,
Weird issue I've been having.
I recently installed the infotainment aftermarket back up camera and opted out of the programmer since I have alfaobd. I've unlocked all the proper settings. The two issues I see are the following:
1) Back up camera does not turn in. Blue screen camera...
Just recently did a Rambox swap from a standard crew cab bed. However, I don't have the necessary harness to connect the locks and LED lights that the new Rambox came with. Anyone willing to share some photos or possibly check if a part number is available for such a wire harness. Thanks in advance.
Recently did a Rambox bed swap and also have the two connectors on each side for locks/lights. Is there a part number for the wire harness? Where do those connectors plug into? Thanks in advance
I've searched and couldn't find a post that shared wiring details. I have a 13 Ram Sport that initially came with a standard crew cab bed. I've since swapped in from a 16 Rambox. Everything bolted up just fine however, I have two extra connectors on both side which I presume are for locks on the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.