Reading the forum, I came across someone that said that the original 4th gen USB ports will work with the new radio(UAQ & UAS). The only caveat is that the Android Auto works and Apple car play will not work.
I've been looking for the answer on that one to. Technically, it should work like a USB. The RA4 apparently will work when wired like that.
I'm looking to move the Android Auto plug closer to the radio and just want to use an aftermarket USB port.
The gears were switched out last week.
So far off the start the truck is noticeably more responsive. I've done some towing and found that over 100km\hr the truck losses power and has issues with down shifting. The speedometer was off by a few km\hr. That said the ratio was not put into the...
Just dropped off the truck with the shop! Asked about the speedometer and confirmed that I need to use a tune of some sort to correct the speedometer. The speedometer runs off the Vehicle Speed Sensor in the transmission.
I don't really know much about the tuners. I've seen the superchips and things like that.
Yes the truck is 4X4. I hope the install doesn't break the bank!
The cost so far has been just under $2k(CAD) for the gears. The shop I'm taking it to works by the hour and I'll see that labour costs next week.
For the ratio, has anyone set the gears in alphaobd? I would hate to buy a device just for one purpose.
I've pulled the trigger on a set of 4.56 gears and they will be installed next week. The truck is a 2014 Ram 2500 5.7L mostly used for towing on stock tires. The swap will be done by a qualified drive-line shop.
Is there anything that I need to know about the swap? Is there any programming...
So... I switched out my winter tires (Duratracs) for my summer tires (Michelin LTX AT2) and the clicking went away.
I'm currently planning to switch out my gears 3.73 for 4.56 and I'm getting quite a range of pricing from about $2800-$4200(Canadian dollars). I assume if there is any issues in...
The truck has been making a little noise for a while, but it seems to be more pronounced at this point. I'm figuring that it is a u-joint. The truck only makes noise when in reverse and shutters just a bit when you put it in drive. I did replace the diff fluid last week and it was quite dirty...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.