Any suggestions where to get a stock forged 6.1 Hemi crankshaft in stock 3.578" stroke? I've scoured the internet and come up empty handed. Looking to replace my cast 5.7 crank with a forged crank and keep current displacement. Thanks in advance!
Left Lane, #16
2015 Crew Cab 2WD. Still need to get her dialed in. This run was full weight (5700lbs) and almost full tank of gas.
Procharger D1SC 8lbs
50/50 Methanol Injection
MMX SC Cam
Ported 5.7 intake
Moes 87mm ported TB
Stainless Works 1 7/8" Full Length Headers
Corsa Catback
QTP...
Following as well. Can't seem to get ahold of Matt at Moes for the last 3 weeks. Circle D recommended a 3200 stall for me (occasionally tow a 3000lb trailer, 8 speed 3.21 gears.) I am planning a Whipple in fall.
I used to tune with efilive when I had my LS1 Trans Am, so I'm familiar with ecu parameter changes.
I do have a question though on the android vs windows. I have a laptop with windows 10, and an android phone. I'm guessing I'd be better off going with windows for sake of being able to...
2015 Ram 1500 5.7 Hemi. What's the best way to do this myself (without taking it to the dealer?) Can you recommend the best way to accomplish this (alfaobd, etc). I'd rather spend my money on a software platform than pay the dealer labor. Thanks!
I'm selling my Edge Pulsar #32450. I ran this for a year and a half on my 2015 Ram 1500. Noticable "seat of the pants" power increase on settings # 6 and #8. I had no issues with it at all, my powertrain warranty is up so now I'm going with a full tune. I have not done any updates on the...
I just ordered a fox acoustics dual ported 12" box for my 2015 Ram 1500 Crew Cab.
How are you guys anchoring this box?
Usually I'd just drill through the bottom of the box and floorboard and run a bolt through but I don't see the plastic tubs being suitable for that.
I have a 2015 Ram 1500 with 5.7 Hemi. I just ordered a Singer 270 amp alternator to keep up with the demands of my stereo (my lights are dimming, even after doing the big 3)
Singer suggests a serpentine belt 1/2" to 1" shorter than OEM due to the smaller pulley used. Anyone have a part #...
I was pulling into a parking lot this morning, my lights dimmed a little and the engine stalled and the check engine light was on.
I pulled the code and it's P0335 for Crankshaft Position Sensor. I tried clearing out the code but it's a permanent code that it will not allow me to delete. Is...
I'm doing the big 3 upgrade and need some input for where to ground the engine. Some say to use the alternator mounting bolt (#1), or I was even thinking bolt #2?
Where are people bolting their engine ground to? Thanks for the help!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.