Been there done it. You really don't need to pull the entire bed. Remove the bed bolts from the drivers side of the bed, loose up the passenger side but do not remove, just a few turns of the bolt to keep the threads intact. take out tail lights . Remove the filler neck from the side of the bed...
already have the new flywheel i was wondering if there are any suggestions as to which clutch brand to get. The 4.56 gears already turn the 38's just fine. any particular brands to stay with or away from?
I was dealing with the same issue. And i went through everything until i bumped my head and went back to the 3 basics, fuel air spark. I had a bad coil plug. I took my meter and check the resistance on each one, very easy to do, until I found the only one that had a different reading, replaced...
No man its absolutely nothing to it. Pull the kick panel down, easy, then just ease out the middle panel. you do not have to pull the dash. Not even close to that. I can pull mine apart in and pop it back in in less than 30 seconds. Once you ease the panel out its just 4 screws holding the...
I have an 04 and it did the same thing with the lamp out light. Mine is very sensitive to voltage/amperage. I had some corrosion under my positive battery terminal that I could not see. I cleaned it up and it went away. The next time was when I changed over to led bulbs. Even though everyone of...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.