Recent content by RHorseUSMC

  1. RHorseUSMC

    Alpha Rex issue - need turn signal bulb socket

    So I finally got around to taking care of the socket. Just in case anyone ever runs into this issue, I've attached a photo of socket for 2012. It will need a slight modification in order for the hardness to plug into the socket. There is an extra tab of plastic that needs to be removed in...
  2. RHorseUSMC

    Alpha Rex issue - need turn signal bulb socket

    So after installing the Alpha Rex Luxx series headlights in my 2013 Ram 1500, I quickly noticed and issue with one of the lights "flirting" or "bouncing" in the housing. Nick @GotExhaust has been extremely helpful in getting it taking care of but the issue happened when I sent the headlight...
  3. RHorseUSMC

    Bedliner suggestions for a first time truck owner?

    I have had the DualLiner in my 2013 since new and love it. It fits perfectly and no slip. I haul tools and equipment daily. l also have the BakFlip G2 tri-fold hard cover, also since new. The cover has worked very well but the seals at the fold points have developed a very small split ( from...
  4. RHorseUSMC

    Alpha Rex headlight upgrade and Alpha OBD

    I am looking to upgrade my factory projector housings on my 2013 Ram 1500 due to a moisture issue in both of them that I am tired of fighting with. Anyway - the Alpha Rex seem to have good reviews and I am looking at the "09-18 Ran Truck LUXX- Series LED Projector Headlights Alpha-Black" but it...
  5. RHorseUSMC

    Just finished the Uconnect 8.4 VP4 upgrade

    I could not have done this without the information found on this forum. The right up with the detailed instruction is perfect. The wiring harnesses from M2 Mods are top notch! Even got it a little earlier than expected. Here is a quick note on my setup and parts used and the total cost...
  6. RHorseUSMC

    PRND all light up yellow

    I was wondering if anyone has had this issue and how you resolved it. Over the last several months I have noticed that the gear selector will sometimes light up yellow when switching from park to drive. There are no CEL. My truck is a 2013 Ram 1500 with the 6spd. What little bit of...
  7. RHorseUSMC

    Throwing a code

    I guess the code is one that needs so many cycles to clear. It actually cleared a few minutes ago when I started the truck. Whatever it was I must have fixed it when I had the cover off. Thanks for the reply. I will keep that in mind in the future.
  8. RHorseUSMC

    Throwing a code

    So I popped the hood on my 2013 Ram 1500 just so I could make sure it was 5w-20 oil that I needed to get and when I did I noticed the big plastic engine cover was tilted a little to the side and was loose. Last weekend I had pulled it off along with the S&B intake tube and did a good cleaning...
  9. RHorseUSMC

    Water dripping under glove box

    Hey guys- I noticed when backing in my driveway the other day water started dripping under the glove box and hitting the floor very close to the fire well before running down the mat. My truck is a 2013 crew cab. I'm assuming it's something with A/C because it hasn't rained in days. Anything...
  10. RHorseUSMC

    Anyone else brick their Ram trying to load a tune?

    Apparently there is an issue affecting some '13-'15 Chryslers, finally got the truck running again after Garrett at Diablo helped me out tremendously. Only took all day to get it resolved lol. I think I'll wait until Monday to try loading any tunes.
  11. RHorseUSMC

    Anyone else brick their Ram trying to load a tune?

    After getting my Magnaflow 18" installed yesterday I came home and my Diablesport tuner was here. Following the instructions I updated the software, updated the PCM, created a backup of the PCM, then attempted to load a tune. 99% completed and it gets an error and trys to revert back to...
  12. RHorseUSMC

    30 days with Carven, swapped to Magnaflow 18" today

    I'm hoping it does a little. I like it so much better. Real test will be when I pull the camper next week.
  13. RHorseUSMC

    30 days with Carven, swapped to Magnaflow 18" today

    Yep left everything on just swapped the muffler. Sounded great on the outside. Just hard when your pulling a camper to talk or even here the radio. I'm sure the exhaust just bounced between the tailgate and front if the camper too.
  14. RHorseUSMC

    30 days with Carven, swapped to Magnaflow 18" today

    i guess I don't have enough posts yet to list it?
  15. RHorseUSMC

    30 days with Carven, swapped to Magnaflow 18" today

    I had a Carven AR mufler and y-adapter installed on July 6th and I absolutely loved the sound my Hemi was making. Constantly turned heads. Always driving with the windows down so I could here it. But after towing our camper on a recent camping trip, I've decided the interior noise was a bit...
See more

Latest posts

Staff online

Members online

... and 7 more.
Total: 1,276 (members: 57, guests: 1,219)
Robots: 1,889

Forum statistics

Threads
195,596
Posts
2,872,306
Members
156,397
Latest member
Bobbers

Share this page

Top