S
sdeeter19555
- Posts
- 61
- Reaction score
- 45
Latest activity Postings About
-
-
Ssdeeter19555 replied to the thread Rough cost to replace head gasket?.I should say, I'm not automotive illiterate...if i had the time, I could tear this down and rebuild myself. I know what I'm looking at...
-
Ssdeeter19555 replied to the thread Rough cost to replace head gasket?.Coolant...
-
Ssdeeter19555 replied to the thread Rough cost to replace head gasket?.Absolutely sure it's a head gasket, I can see where it's leaking at the seam between the block and head. Truck hasn't been overheated...
-
SThe head gasket on this 2019 Laramie 5.7l is leaking at the driver's rear and dripping onto the ground. Truck has 40k miles... Nothing...
-
Ssdeeter19555 replied to the thread JASPER ENGINES OE vs OE MDS DELETE.In my observation, MDS only operates at very low load and even limited on highway. I've played with it and have seen almost no...
-
Ssdeeter19555 replied to the thread Tire pressure.The other thing to consider is the TPMS, my Chevy 2500HD are set to trigger at less than 65psi rear and less than 60psi front from...
-
Ssdeeter19555 replied to the thread Tire pressure.Most tire manufacturers have charts for air pressure versus load. For someone running a LRE on a daily driver that isn't actually using...
-
Ssdeeter19555 replied to the thread Exhaust Manifolds.One thing I noticed is that these cast iron "header" type manifolds have less material than the old style boat anchors they used in the...
-
SThe listed torque values are 130-140 ft. lbs. I lubricate my threads and go to 110 ft. lbs. with a torque stick. Others will have...
-
STook my 2019 into the dealership last week for an oil change. While they had it in they checked the brakes and airfilter, they came and...
-
Ssdeeter19555 replied to the thread Tonneau cover.Bakflip are hard to beat... I have one on my 2012 Silverado that was installed new. It's showing some wear, but not much for the age...
-
Ssdeeter19555 replied to the thread Black, Chrome, Color Matched - What is Your Preferance?.I think it depends on the body color...there is nothing sharper (to me) than chrome on metallic black. But I do have one that has...
-
-
Ssdeeter19555 replied to the thread front end grease points.If i remember correctly, not many. They used sealed ujoints and sealed ball joints, the tire rod ends and drag link may have zerks...
-
SI believe I will get a torque stick , I’ve seen them , but never gave them much thought . Although I’m never in much of a hurry when I...
-
Ssdeeter19555 replied to the thread Retorquing lug nuts.I bought an 85 lb-ft torque stick to run mine on (to prevent over torquing)...run them down snug, set it on the ground, then use a...
-
-
Loading…
-
Loading…
Latest posts
-
-
1989 W150 Forest Service truck resto - nickname "Govt Chz" - Stoffregen Motorsports- Latest: Stoffregen Motors
-
-
-
Staff online
-
ShaggyAdministrator/Owner
Members online
- TXd150
- CanuckRam1313
- GeauxinUp
- stevieb92
- Bob Horowski
- QwikKota
- Stoffregen Motors
- crackerjack1957
- Goose55
- RamDiver
- Shaggy
- Dean2
- Harley Harrold
- Rh18
- express2014
- ExpressRules
- Down the Tubes
- diamond Wrenches
- TreBoneius
- diymirage
- JoshsRam
- aszumilo
- truck2014
- Bmags
- chadm40
- pcalliga
- derekmarion43
- Curmudgeon
- Fritter
- Wolfman5700
- alabama2018
- Margaretfra
- shogan
- Mojo88
- Adrock1981