I recommend pulling the inner panels and removing the glass (not actually removing it but taping it up using masking tape). Its a world of difference if you can apply sound deadener and proofing material on the door skins. I'm at a point where I can get the door bare in 5min. The hardest part of...
Good luck! I did this about a month ago. I actually have one more door to do. I too used the Noico sound deadener (80mil) throughout and put Second Skin Luxury Liner Pro MLV + Foam on top of that from front to back. I used Noico Red sound proofing foam on the back panel and roof. The hardest...
I'm going to need new tires to replace these RSA's really soon so I've been looking at lifts to accommodate 33"s on 20x10 negative offset wheels. I'm torn between the Rough Country kit which uses spacers and comes with with new UCA's, or putting the adjustable Bilstein's all the way around. I'm...
I installed the Innovited kit last Saturday. So far so good. I do have to pull the driver's side back out and adjust the vent caps due to condensation.
Sent from my SM-G965U using Tapatalk
Took mine into the dealer for the same issue after noticing it for the 1st time, leaking driver side grab handle, top screw. Dealer told me its a leak in the windshield where it seals. They couldn't fix it so I called a local windshield glass co. I was told its not uncommon and they can usually...
So I did the premium cluster swap two weeks ago and I was able to get the idle and engine hours to update only with the ignition set to ACC. It failed and did not update with the key set to RUN.
I was able to adjust the odometer on the first attempt even though alfaobd said the procedure...
I too have vibration right around 70mph. First time I took it in the dealer rotated and road force balanced. This was on a Saturday. On Monday they called for a follow up. I told the service writer that the vibration was still present. Took it back in again and dropped it off 8am on a...
This guy didn't have any issues. I think the part that a lot of people aren't doing is the VIN write to the cluster so I would try that and see if you're still getting errors.
Video was uploaded only a few days ago. AlfaOBD walk through starts at 13:30
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.