My little ole 01 Dodge 2500 has a 6 speed,course it's behind a Cummins. Power?? It'll yank the slime off a swamp, not to mention pull my 14k 5th. wheel.
Did I want a 6 speed....No, but wasn't about to put that CHEAP Chrysler auto behind that diesel.
Have an 01 Dodge 2500 Cummins diesel with the "infamous" lift pump that sets on the left side of the engine close to the fire wall. By 03 I was on my 4th. pump. Called Cummins, explained the problem. They were "Shocked", said it was the first they had heard of the problem. Couple times a year...
Have a 2001 2500 diesel 6 speed with a salvage title. "Totaled" it, about 5 years ago, windshield, hood, grill. left front fender, front bumper,some striping.
Have been told ,because it's a 6 speed, it's in high demand.....How high? Don't know.
Have an 01 2500 6 speed diesel, bought new, About 5 years ago"someone" sneaked up in the middle of the night and disabled the clutch switch to the starter. That means it could be started without depressing the clutch.
So, the vehicle was just outside the garage and I was standing outside the...
FWIW; Have a 01 2500 Dodge diesel with a 6th. speed bought in 00 with a 15k Reese 5th. wheel hitch. Been pulling a 33 foot Discovery by Hitchicker with 3 slides since 01.
Weight of 5th. wheel loaded around 13,500 lbs. Average speed 67 1/2 mph. Highway speed limit 70 mph. Weight of truck with...
Replaced the ***** clutch couple years ago. Lately having problems starting. Just clicks. Have to pump clutch several times. Checked fluid, full. Thinking about shunting starter wires at clutch.
Thoughts?
Well I found my oil leak. Push rod cover gasket. Texas Diesel Power wants $500 to replace. They charge $90 an hour labor which is cheaper than the dealership. Don't blame em. I'd probably charge more. Gonna tackle it next week. Done enough research. Parts gonna run about 30 bucks, unless I...
Thanks, BTW I should have indicated that these are deep sockets. A standard wont fit.
Also, Loews, Homedepot or Ace don't carry anything that large, Norther Tools does and probably Sears.
2001 Dodge Diesel 5.9
Gotta oil leak on left side near rear of engine. "Think" its the oil pressure sensor/switch, which is a solid state 3 wire sensor controlled by the ECM. This stupid sensor, like most all sensors, are difficult to even see, much less get to. After disconnecting both...
Yesterday code PO341 set. Book says: "Problem with voltage signal from CMP"(camshaft position sensor). O'Reilly's wants 62 bucks plus tax, found 1 on ebay for $20 & change with free shipping.
Question: How to erase code after installation?
TIA
SR/WA
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.