Recent content by the_nid

  1. T

    How To: Add Factory Keyless Enter N Go

    Got a new hub, installed it and push start works great now! Though the new RF Hub has a pin '0000' which I'm assuming is default. How do I set a new pin for it (should I even do that)?
  2. T

    All Repair Parts @ Employee Cost!

    Hi Benny, I'm looking for the following: RF Hub - 56029946AB Hood latch - 68159725AB
  3. T

    How To: Add Factory Keyless Enter N Go

    Yes, it is. Well, crap, did I just burn two key fobs as well!? Is there a way to reuse them?
  4. T

    How To: Add Factory Keyless Enter N Go

    Alright so a few observations. I reconnected the old RF hub and ignition module and the truck started right up with no issues. I then connected the new RF hub and new push button ignition module, did an RF hub reset in Alpa and was able to start the truck. It only ran for 1-2 seconds and then...
  5. T

    How To: Add Factory Keyless Enter N Go

    Tried it, it didn't. I did notice though that as I was stepping on the brake and pushing the start button with the fob it still showed the message of press the brake and push start. The best it did was change the power state of the start button into run.
  6. T

    How To: Add Factory Keyless Enter N Go

    I'm running into a problem where after installing the RF hub, two in-cab antennas, push-start ignition switch and programming 2 new fobs the truck will not start. I could use any and all help! Initially after I wired up the RF hub, antennas, new ignition switch and programmed the keys I totally...
  7. T

    How To: Add Factory Keyless Enter N Go

    Does anyone know where I can buy the 174910-2 connector or two (not 10k)? Or would someone will be willing to sell an extra one they have?
  8. T

    How To Add rear Park assist

    I bought another park assist module, because all these "bad" sensors are making me wonder if there is possibly something wrong with the one I have. My truck is a 2018 model and the module seems to be up to 2017...though it appears to work. Once I get the new one I'll check to see if the current...
  9. T

    How To Add rear Park assist

    Yes, I have to verify that there wasn't something like that. I also find it super strange that so many appear to be non-working. If there is a way to test the sensors themselves individually I would like to know so I could do that.
  10. T

    How To Add rear Park assist

    Does anyone have a link to a good place to buy sensors from? I've bought 5 different sets now and in all of them at most 1/2 work!
  11. T

    How To Add rear Park assist

    I appreciate all your suggestions and advice....plus the tons of content you had already added to this thread!
  12. T

    How To Add rear Park assist

    Well, I guess I stand corrected. It's apparently possible to buy 3 sets of totally faulty sensors from 3 different sources! Looks like I have 4 good ones out of 18 total. One-by-one I swapped them out util I found 4 that work and rear park assist now works! Just need to order 40 more and I...
  13. T

    How To Add rear Park assist

    Got the new sensors in and seeing basically the same thing...though when I run the wiring test it's coming back with only 2 sensors having fault codes. I check the voltage at the rear harness to make sure the power and ground weren't reversed, they were not. I suppose I could have miss-wired...
  14. T

    How To Add rear Park assist

    Pretty sure canbus is correct. I tried reversing the wires and got errors stating that the park assist was not found. I bought new sensors and will try them when they get here.
  15. T

    How To Add rear Park assist

    I bought the module on eBay, but if it was defective I would expect to see something in the faults with Alfa. The sensors are Bosch...bought those on eBay as well.
Top