Recent content by wyo2track
-
6.4 Hemi miles?
Hey Bearcatrp thanks for that first hand experience. I have drove a 2020 6.4 with the 8 spd. Dropped by our local small town dealer when they were slow one day and took it up some nice 1/3mile long 6% grades just outside of Town. That truck with 3.73's was a totally different experience in...- wyo2track
- Post #14
- Forum: Heavy Duty
-
6.4 Hemi - 8 Year Report
Appreciate the information you provided as well at the OCI regarding temp stability. I haven't changed the transmission oil so I'm probably due. Most the time I never see engine oil temps above 205F unless I'm working it, but that's only 15% of its life. Heck, during colder months, Nov. -...- wyo2track
- Post #25
- Forum: Heavy Duty
-
6.4 Hemi - 8 Year Report
81k on my 2014. Engine is strong. Wish I had the 8 spd but have not had any issues with the 6 spd some have had but many have not. After reading this thread think I'll be changing my transmission oil to the Amsoil...good info. Have had a few hiccups; clutch fan under warranty and the one that's...- wyo2track
- Post #23
- Forum: Heavy Duty
-
6.4 Hemi miles?
81k on my 2014. Engine is strong. Wish I had the 8 spd but have not had any issues with the 6 spd some have had but many have not. Have had a few hiccups; clutch fan under warranty and the one that's on there now acts up now and then. Out of warranty, out of pocket; rear u joint, cracked...- wyo2track
- Post #11
- Forum: Heavy Duty
-
In shock and a migrane!!
A 3 day trip to eastern wyoming and back to the west side. Crossed 3 mountain ranges, battled wind, snow, 65 to 75 mph speed limits, morning temps in the single digits warming into the 30s. 2014 with 4.10's. The 6.4 is most efficient when temps above 50. Wish I had the 8 speed when towing...- wyo2track
- Post #40
- Forum: Heavy Duty
-
Disappointing MPG
New truck and worse time of year to measure diesel mileage with blended fuel. With that however its no secret to expect 11-12 towing on the upper end.- wyo2track
- Post #10
- Forum: Heavy Duty
-
2013 2500 6.7 w/ 70k purchase?
If my memory serves me correctly, the 2500 trucks did not get the updated 3-link front end until 2014, but did get the most updated engine, emissions, and transmission at the time. Prior to the 3-link it's my understanding that there were problems with ball joints failing especially in the...- wyo2track
- Post #4
- Forum: Heavy Duty
-
0W-40 in 5.7 HEMI and 6.4 HEMI
Castrol Euro 0W-40 here too for my 2014 6.4 Hemi. Cannot find PUP anywhere in the stores around me. Have used Castrol for the last 6 oil changes. Has less produced less lifter noise at startup than when the dealer did my first 3 oil changes with PUP. Think I'll run a Blackstone analysis at...- wyo2track
- Post #20
- Forum: Engine & Performance
-
TFL’s 6.4 test
There's a good chance that with an additional 2K that with 4.10's the truck would run slower than it did with 3.73 and 14k. With 3.73, it could only run about 45 mph and it was at its rev limit in 2nd gear. With 4.10's, it'll hit the rev limit sooner at a lower speed if it cannot hold the...- wyo2track
- Post #7
- Forum: Heavy Duty
-
TFL’s 6.4 test
Better downhill braking programming needed. About what I expected uphill. Much better than the 6 spd towing 12,500 with 4.10's going uphill. At least the 8 spd will downshift even when oil temps were around 250. Must have grabbed second gear when it did. Its a good package that'll provide...- wyo2track
- Post #2
- Forum: Heavy Duty
-
2018 vs 2019 6.4
I've only run stock air filters and my tailpipe is black on my 14 and I have only 63k on the truck. These 6.4's run a little rich I think.- wyo2track
- Post #9
- Forum: Heavy Duty
-
Have they ran the 6.4 with the 8 spd up the Ike
Looks like they're driving one back to Colorado for testing. Air suspension and 3.73's.- wyo2track
- Post #42
- Forum: Heavy Duty
-
My truck sounds like an air boat
On my second clutch fan in my 14. RAM replaced first on around 20,000 miles. Would never disengage. 2nd one is starting to behave the same way at 60,000. Once truck is warmed up manual shift it to rev rpm up to around 4500 and fluid in clutch will finally flow and let clutch move...- wyo2track
- Post #11
- Forum: Heavy Duty
-
-
Pedal Commander For Sale
LOL... These forums are all different I've sold **** on. Some don't like full sentences, others need it word for word.
Members online
- Black-Wolf
- s_wall98
- tzmndvl308
- aszumilo
- fhc50cent
- Dyeelitt
- RamDiver
- jojo6699
- Shawn Burns
- Northern_Casper
- Wild one
- Racer9
- lefave15
- 392DevilDog
- Atcer2018
- corneileous
- Suma Performance
- Mike Flea
- keeponcummin
- teddy Charlery
- jabartram
- Th3K1ng
- c85jl
- Craze82eny
- HydroTopzz
- Joe Wales
- Killsek
- crackerjack1957
- DontdodgeRam-em
- DeckArtist
- Hootbro
- Houston1414
- netshadoe
- FarmerFramer
- Bigfoots03hd
- 4x4RAM1500
- Mrsmith4
- mrack
- hdog33
- Heathen-19
- MThompke