Recent content by Xyleff
-
Removing and replacing fender flares on 2022 Power Wagon.
I was wondering the same thing. How does one go about in taking them off exactly? I sprayed in between the body and flares on the lower ends near tail pipe and rear door and it was non stop mud water gushing out for good 5 minutes. Also sprayed from inside the wheel well out and same result...- Xyleff
- Post #5
- Forum: Dodge Ram Power Wagon
-
Taking on Water...
Yeah, just gotta fiddle with it. It was a PITA for me. I actually broke one of the little tabs on the right side on both but that didn’t effect anything. It still clicked in and held. Check your rear sliding windows also. I need to find those holes as well, if someone can point them out. -
-
35w or 55w HIDS
Have you had any issues with the bulbs going out or had to replace since converting? -
Leaky Brake Light Fixed
Did you guys overlap the bottom strip with the one that goes around the top, or precisely cut where the ends meet? -
35w or 55w HIDS
thanks. Very informative. Trying to get by without having to get alfaobd. -
-
35w or 55w HIDS
did you do setting changes in the bcm for headlights to “HIDS” or straight plug and play? -
35w or 55w HIDS
Preferably 5000k lows and 3000k fogs for me. My concern between the 35w and 55w was the heat, if that would be any issue. -
35w or 55w HIDS
Bulb swap. I’ve looked into LED but i have projectors. Is that what you have with the LEDS? -
35w or 55w HIDS
I have a 2014 1500 w/factory projectors. Im looking into HID kits but don’t know which to get between the 35w or 55w. Does it matter?? Also, I don’t have alfaobd and have no plans to get it. Will this be an issue? -
Rear seat torque specs
I did exactly that with a little tab of blue loctite. -
Rear seat torque specs
Sorry, I should’ve been more specific. I meant the bolts to the seats. -
Rear seat torque specs
I’m replacing the cab vents. For those that have done it, do you guys/gals just tighten bolts as much as possible or actually torque them to spec? What are the torque specs? And is it necessary to use any loctite? Blue or red? -
Fold flat floor trim
Bump.. has anyone been able to 3d print this piece??
