Based on the description on the page, when you remove the existing Alpine amp, this plugs into the factory wiring harness so you can get audio signal and other necessary functions to your aftermarket amp without splicing wires
Here is a thread on the Clutch delete plate. I took some pictures of how I have things setup. I park in a driveway so I cannot help with the clearance issues.
I see all these pictures of people with complex setups so I think mine is pretty boring.
I have a Cobra 75 WX ST I have it sitting under the passenger seat unsecured with the mic hanging from the passenger side cubby in the center stack. I am essentially running power directly from the...
In the past when I have installed a ham radio into my vehicles I have always gone directly to the battery.
When I purchased my truck the finance guy warned against splicing into fuses or attaching things directly to the battery because "...vehicles made after 2016 are considered advanced modern...
I am using Mopar's Roll-up Tonneau Cover. It installed quickly and is not too much trouble to roll up if you do not want the bed covered. I have no experience with other bed covers so you should probably factor that in. If you want pictures of the cover on my truck I'll post them later.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.