What else might it be

Christinawillis78 · Apr 22, 2019

2001 dodge ram extended cab1500 5.9 replaced fuel pump cuz wasmt getting fuel to rail. It is now and even the right amount of pressure. It will crank but still not start I'm replacing the plugs tomorrow. Any other ideas what it could be.

DodgeTx · Apr 22, 2019

do the key on key off test, and report back the codes it shows. Could be a sensor bad or bad pcm, had this issue before on my old 2000 5.9l v8 1500. Replaced a bunch of sensors and ended up having to replace the computer. If it does come to the computer, buy one with a lifetime warranty. Mine ended up dying a few years later, and I sold the truck. it is worth the extra $50 believe me.

Hero6 · Apr 26, 2019

You have fuel, now do you have spark? Check while you are changing the plugs.

Yeret · Apr 27, 2019

Did you check fuel pressure while cranking the engine, or did you only check it after turning the power on?

Dave2018 · May 26, 2019

I've had both a crankshaft position sensor and a fuel pump fail on my 1998. Both left me stranded on the side of the road. The crankshaft position sensor is on the passenger side on the rear block.

dick strough · May 27, 2019

Just had same problem, same truck. With good advice, it was my cam sensor under the distributor cap. You can go play by play on page 2 under, cranks/no start unless.

What else might it be

Christinawillis78

Junior Member

DodgeTx

Senior Member

Hero6

Member

Yeret

The Village Drunk

Dave2018

Senior Member

dick strough

Member

Similar threads

Latest posts

Members online

Forum statistics

Share this page