Problem rotating 6.7 by hand

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

Miki

Junior Member
Joined
Nov 5, 2016
Posts
7
Reaction score
16
Ram Year
2011
Engine
Hemi 5.7
Hello, did some ARP head studs today. Took all the rocker arms off and kept in order, re installed and went to turn the crank to TDC.

Half way through the rotation it suddenly stops. No amount of force will push it further.

Tried the other direction and still it stops

Trucks a daily driver.

Only issue i had while doing the arp install was when the pushrods were going back in sometimes they could drop too far, and they would sink almost to the top of the rod

Any help would be really appreciated thank you
 

Daw14

Senior Member
Joined
Nov 29, 2017
Posts
2,029
Reaction score
2,079
Ram Year
2014
Engine
5.7 hemi
Start to recheck all of your work,it wasn’t like that when you began ,double check you erred somewhere.
 
OP
OP
M

Miki

Junior Member
Joined
Nov 5, 2016
Posts
7
Reaction score
16
Ram Year
2011
Engine
Hemi 5.7
Found my issue. Most likely didnt seat a pushrod properly and now my rods bent ☹
 
Top