Sierra
Junior Member
Hello everyone!
I am looking for some suggestions because I am sure I am not the first to experience this problem…
I recently had a truck accessory shop install a Fab Fours Black Steel Elite Bumper on my Ram Sport 1500. In the process, the fender liner did not fit well with the bumper. As a result, the there were less fasteners… approaching 45 MPH, the draft would push the fender liners into the tires. Long story short, the fender liners were trimmed. However, the trimmed fender liners now leave the fog light electrical wiring more direct exposure to mud and snow. See attached pictures.
I’m looking for constructive suggestions. Like… buy new fender liners and try this again? Any after-market kits to fix this?
Thank you!
I am looking for some suggestions because I am sure I am not the first to experience this problem…
I recently had a truck accessory shop install a Fab Fours Black Steel Elite Bumper on my Ram Sport 1500. In the process, the fender liner did not fit well with the bumper. As a result, the there were less fasteners… approaching 45 MPH, the draft would push the fender liners into the tires. Long story short, the fender liners were trimmed. However, the trimmed fender liners now leave the fog light electrical wiring more direct exposure to mud and snow. See attached pictures.
I’m looking for constructive suggestions. Like… buy new fender liners and try this again? Any after-market kits to fix this?
Thank you!