Search results

  1. buckeyexx

    6.4 exhaust manifold project

    Getting ready to tackle the passenger side exhaust manifold. Didn’t take long to find the broken bolts. Both bolts on rear holding heat shield are broke. From what I can see so far they are at least not broke flush with the head. I plan on spraying them down with Kroil the day before I start...
  2. buckeyexx

    Solo performance MR400 on 6.4

    Finished installing the solo performance mr400. Ordered from gotexhaust about a week ago and came within 5 days. It sounds amazing with very little drone inside the cab. Being that my truck is a 2015 I had to cut one of the clamps off but no big deal since the new one comes with it’s own. Total...
  3. buckeyexx

    Trans gasket

    For you guys that have used a rubber gasket for the trans pan. Did you also use any silicone to help seal the pan? Getting ready to swap out fluid and bought a new rubber gasket and most videos I watch have people using just silicone only. Thanks in advance. Sent from my iPhone using Tapatalk
  4. buckeyexx

    L.E.D. Tinted cab lights

    Had some condensation in two of my cab lights from over tightening the screws so ordered new tinted ones. See how they hold up. I reused the rubber factory seal pads and screws as the new ones were made of foam. Sent from my iPhone using Tapatalk
  5. buckeyexx

    Engine temps when cold outside?

    What coolant temp with the 6.4 is everybody running at when it’s say in the 20-30 degree mark? I’m asking because I have yet to see my temperature get above 185. This is while driving around town and driving on the freeway for an hour drive. And when it gets up to that point it stays there...
  6. buckeyexx

    Upgrade to 6.4

    After a long debate with myself I have finally decided to trade the 2011 ram in for a 2015 ram 2500 tradesman with the 6.4 Hemi. Sent from my iPhone using Tapatalk
  7. buckeyexx

    Spark plug change

    Finally got around to changing the plugs today. Other than the fact they were almost double the gap they really look pretty good. With 218000 on a 4.7 I was expecting oil coated around them. Sent from my iPhone using Tapatalk
  8. buckeyexx

    Truck will not start! No codes?

    Well I have a 2003 with the 4.7 that just recently turned over 200,000 miles. The truck had been running great until now. When I left work today it ran normal with no problems but when I shut it off to run into a friends house for about an hour or so it would not run when I went to leave. It...
  9. buckeyexx

    Newbie from Ohio

    It's an 03 with the 4.7 and 4x4 with just over 200000 miles on it! Needs some minor work but runs great. Sent from my iPhone using Tapatalk
Top