Could also be the AC clutch area.
I looked at those emblems in his pictures and thought, well those look like they are attached well.
lol so much for looks.
Motor mount will not usually show in neutral, no real load to move it.
I have seen mounts in other vehicles move enough to barely touch something...
This is going to sound crazy, but could it be a bad serpentine belt or something up in that area?
Or motor mount play that is letting the motor...
I don't mainly because I don't drive the truck often.
If I was going to, I would buy tube sand and have 2-4 of those in the bed. Can come in...
Since he can see that it is pulling timing, can he see if it is pulling timing due to the det sensors telling the computer that the motor is pinging?
That's the prime rpm range that people complain about drone at too.
It might just be the exhaust and the way it is going to sound.
Hard to tell...
Maybe a gasket leak at the head?
It's definitely a lot noisier than my stock truck :)
I am assuming you have MDS turned off via the tune?
Will it make the sound just revving it to those rpms or do you have to be moving?
Well, if it's a rattle, it isn't from so much flow.
Try crawling under there with a soft rubber mallet and smack the exhaust in several places to...
The biggest thing to make sure of, by far, is that the trailer brakes work and stop the trailer WITH the load on it.
On my boat trailer, I have...
Yeah and that seems about right. You would always want the GVWR to be less than the weakest link - be it axles, brakes, tires, etc.
It seems as...
If it's nice and shifts nice, you should be ok.
At those miles, is there any service history? Has the transmission fluid and filter been...
After thinking about it, I don't know if it would work correctly for you or not even if you have the clearance.
I don't know if the calibration...
The 17 rear axle rating is only 3900#, the 5th gen axle is rated at 4100#.
I have the 12" wide set on my 1500 - they are one heavy piece of rubber!
I have to make sure and see what box it fits in and shipping cost but I was thinking $20 might cover it shipped.
I have a like new ( was only installed for a test and taken off) mopar 52028799ac.
It seems as if the rotation is correct, HOWEVER the nut is...
It should be done changing, it has been heat cycled plenty :)
They say to use the Remflex gaskets but I don't have any experience with them.
If you are going to plane them, you can do that now too.
Might be easier now if the bolts come out vs. playing with a broken bolt - either way you go.
Sounds a bit high, but the condition matters and truck prices are stupid high right now.
Did you try plugging it into kbb.com
Do you know what the factory part number of the original clutch is?
You will enjoy that combo for your use - it is where that combo shines.
Even with a 3.21 it would be a step up from your 19 in performance - the 8...
Running LT will probably wear less when constantly heavy loaded vs. some P rated tires and will handle the heat from being loaded much better.
I just figured that you really really liked that model hahaha
Separate names with a comma.