Search results

  1. M

    Cv axle/intermediate shaft blown out

    Hi! I’m curious if this is the typical intermediate shaft issue or if the cv axle is missing a retaining ring? Excuse my ignorance if I’m wrong. Thanks guys! https://youtube.com/shorts/BOCoij9ER68?si=ESu0amSECAavBItk
  2. M

    Fuel Pump

    I had the same issue and this was my issue. I replaced with a Delphi pump in November and haven’t had any problems yet :)
  3. M

    Odd noise from a pulley? Not sure

    Thanks for the advice! I just recently in the past few thousand miles had a water pump and serpentine belt replaced. When I was looking at all the pulleys I think I could just barely see the slightest wobble on the tensioner. Seems louder on the passenger side which I thought was odd
  4. M

    Odd noise from a pulley? Not sure

    I have this odd noise that is much quieter in person but the phone captured it loudly. I’d like to assume a pulley but it has an odd sound that I can’t quite place. https://youtube.com/shorts/hBC2Lff72xQ?feature=share Any help would be appreciated! Thanks :)
  5. M

    Synthetic Oil

    I still have a couple thousand miles left before I change out my Valvoline EP 5w-20 but I was curious on your guys thoughts on possibly switching to HPL super car 0w-30? Probably going to buy a pump from black stone to get an analyis prior to the change. Last change iron content was somewhat...
  6. M

    Purge valve solenoid on and off tick

    The purge valve was definitely noisier than it should be after listening to the new one. she’s all quiet now! Thanks guys
  7. M

    Purge valve solenoid on and off tick

    Sat outside the truck and waited for the tick to come and it is confirmed the purge valve. Held my finger on it and it pulses quite a bit which I’m sure may be normal but I don’t think the sound it makes is. Going to replace and see if it quiets down.
  8. M

    Purge valve solenoid on and off tick

    Thanks fellas! When I get a free chance I’ll check to verify.
  9. M

    Purge valve solenoid on and off tick

    Good advice sir! I’ll try and get to a buddies shop being I have a simple BlueDriver scanner.
  10. M

    Purge valve solenoid on and off tick

    Could be defrost! I keep my heat to the floor/defrost option most often. Excuse my ignorance but would that turn on the clutch and make that noise?
  11. M

    Purge valve solenoid on and off tick

    I’m not positive it’s making the noise but I read it’s possible. Could maybe be on its ways out? Cheap part so it’s not a huge deal if it’s the problem. Just weird how I’ll be standing in front of the truck and it’ll be quiet then start making the click/tick. Same with it stopping the noise...
  12. M

    Purge valve solenoid on and off tick

    I’ve done some research and I have a ticking noise that’s goes on and off intermittently that I noticed at idle. Read that the purge valve activates to release fumes and it’s most likely that. I thought it was noisy injectors at first but the fact it stops every so often then comes back leads me...
  13. M

    Blackstone - used oil analysis

    If you guys go back a page or two and check out my UOA once again do you think it’d be worth a shot to try Lubegard? I just put an order in.
  14. M

    Fuel sensor fail faulty sending unit photos

    2016 ram 1500 Just throwing in that I had the same failure. All seems well after replacement for now.
  15. M

    Blackstone - used oil analysis

    Escanaba area my guy!
  16. M

    Blackstone - used oil analysis

    No towing for me! I plan on trying the lubrication strategy sooner or later but I have no issues currently besides what I think is just noisy injectors. I live in Upper Michigan so it gets quite cold. You still think 5w-30 would be the best option? Potential for -30 degree Fahrenheit or even less
  17. M

    Blackstone - used oil analysis

    Thanks guys! Lots of short trips back and forth to work and the occasional 100-150 round trip drive on the weekend for fishing. Not sure if that could affect my not so great iron number or the TBN. I’ll go to 5k this time. This is also the second oil change on the truck. the first one I had a...
  18. M

    Blackstone - used oil analysis

    Got this truck in February and this is my first UOA with Valvoline Entended Protection 5w-20. Don’t mind the name ;) Any thoughts would be appreciated!
  19. M

    White Ram Gang! Post your pics

    2016 1500 5.7 tradesman Pre and post deer destruction
  20. M

    RamForum Exhaust 4th Gen Clips and Vids

    Paradox mufflers hot tamale. No other modifications https://youtube.com/shorts/6unAX54pUj0?feature=share

Latest posts

Members online

Forum statistics

Threads
196,829
Posts
2,886,932
Members
158,404
Latest member
Demon Hunter 441
Top