I've had my wheels of several times for brakes and etc. and have never really had any problems with the lugs on or off.
And this was posted on another site.
https://static.nhtsa.gov/odi/rcl/2021/RCRIT-21V398-7447.pdf
How do I find out if my 2012 Ram 3500 ST clock spring is a 28 terminal - or - a 24 terminal so I know what to order before I remove the airbag and etc?
I have a 2012 Ram 3500 ST.
Clock went blank while driving (but radio worked fine...) - tried to set time - screen said = "Clock Unavailable"
Got home shut truck off.
Next morning Radio and clock not working. Un-hooked batteries for an hour - re-hooked - still no radio or clock.
I'll check the...
I am looking for the rear / frame mounted canister - screw-on filter because when I buy them from Genos - I get the metal fuel line assembly with the filter for $39.00.
I figured the metal part is just as expensive as the canister - and a reputable aftermarket brand canister only - would be...
I have bought 6 from Genos - but now I have 6 extra of the Mopar frame mounted fuel assembly's.
It's only $39.00 but I really don't need more assembly's.
Plus the motor located nano fuel filter is $77.00 without the canister - filter only...
Ha, Ha, Ha... This is ignorant.
I have a 2012 Ram 3500 4WD Crew Cab ST DUALLY (DRW).
I bought it used with 140,000 miles.
However, after spending almost 3 days trying to match up the 3 REAR MAIN driveshaft U-Joints for a DUALLY (DRW)-
Come to find out my driveshaft calls for SINGLE Rear Wheel U-Joints (SRW)
Is this normal or...
If you don't have a cutting torch or large torch and the small hand held propane torches won't work - you can use a salamander / torpedo heater to get the job done.
https://www.youtube.com/watch?v=fSuu_PW8tAk
Is it possible to run my 2012 3500 4WD without the front drive shaft in - until my U-Joints come in?
I need to make a couple deliveries (200 mile round trip per delivery) before I can get the front U-joints changed.
One of them is squeaking on occasion.
Or will it throw the trans into limp mode...
The "lights" on the buttons on both the Cruise pad on the right and the dash Control pad on the left - go "OFF" when I turn the wheel to 2 O'clock. Then back on at 3 O'clock as the wheel continues around. This does the same in the reverse direction. (The lights basically "flash" off at 2...
If you are in a pinch situation and need to waterproof an automotive (or just low DC voltage) electrical connection - here is a hack when you have no shrink wrap tube available.
I have an Autel / Maxiscan and it works - but when getting the codes from the truck itself - it shows a
P0606 (ECM) / P0685 / P0689 > theses two are related to my Cruise Control not working.
The Maxiscan does not show these.
I also have a Panlong for android - but I haven't downloaded the...
After purchasing - I thought with it being thicker I wouldn't have to grease the cardan every oil change - maybe every other change - but then I did a little research about mixing - I'm just going to exchange it for some lithium.
Mopar suggests NLGI 2 -
But -
Just double checking -
Below are 3 pics of the grease / tube - I bought -
I read where some greases do not mix well with regular lithium types of grease (which lithium is what I have already been using) They say that some greases will "de-activate" each other and...
When I bought my used 2012 Ram 3500 used - as is - the lot had no idea of what this tune (or whatever it is...) for the delete was.
Does anyone here know what I have in the pic?
I accidentally bought a tube of "Boat Trailer Wheel Bearing Grease" which is made for high salt (ocean water) for backing the trailer in to launch a boat. \
Would this stuff be OK to use on the Cardin joint?
(I didn't have my glasses on when purchasing and could only read the "Wheel Bearing"...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.