Search results

  1. MarcoFuc

    High mileage lucas?

    I'm looking to see if anyone has ever used this stuff? I have a loud tick on cold start ups and then at idle when the engine is hot only a steady not so loud tick. I currently use 5w30 full synthetic plat penzoil. With a royal purple bigger filter. I'm just seeing if anyone anyone has used this...
  2. MarcoFuc

    Sticky brake pedal?? Anyone ever experience?

    So I've noticed when Appling my brakes at stop sign or a light or in general, the pedal gets stuck for about 15 seconds and normally my truck at idle when I let go of the break moves on its own. Since I've been noticing my brake pedal getting stuck for a few seconds my truck is at dead stop then...
  3. MarcoFuc

    Low heat/airflow driver side

    yet i even tried burping it as well, someone said when burping it, to rev it a little. it would be a mess but the air pockets would be out. i just dont want to replace the whole thing if its something stupid. I got qouted 2000 to replace the HVAC box but its not a actuator or a blend door so...
  4. MarcoFuc

    Low heat/airflow driver side

    I've been having a issue with my heat on driver side, and other threads I've found or read isn't the same as mine almost similar but not really. So when I have the air on cold I have full strong air flow on driver side, the moment I switch to heat the air is really low flowing out and barely...
  5. MarcoFuc

    HAVC issues?

    So I tried that, and also used a surface temp see if there close or reading the same, both hoses going into the heatercore inlets are reading 128-130.
  6. MarcoFuc

    HAVC issues?

    It's not broken off I took it off earlier to make sure the door was still attached to the plastic piece and then put it back on and it moves perfectly fine when changing the Temps just diver side never changes.
  7. MarcoFuc

    HAVC issues?

    I can try that tomorrow, I did like acouple months ago do a heater core flush of just plain water some black stuff did come out but I've been seeing other post of some adding some cleaner fluid that they pour in there with a hose and let it sit in the heater core for about 15 mins then flush it...
  8. MarcoFuc

    HAVC issues?

    Oh it is? , I do have another bend door, behind my radio/touch screen. I was going based off of this picture that claimed to be for the dual zone
  9. MarcoFuc

    HAVC issues?

    i was looking into that, but isn't that for the passenger side? the passenger side has no issue going from hot to cold, or w.e the temperature i set it too. the driver side is the one thats cold all the time. it is the 8.4 dual zone ATC.
  10. MarcoFuc

    HAVC issues?

    Negative just tested this.
  11. MarcoFuc

    HAVC issues?

    I would have to check on the way back home or when I get off work
  12. MarcoFuc

    HAVC issues?

    I did a cabin air filter about 4 years ago or added one should I say
  13. MarcoFuc

    HAVC issues?

    Thinking what it is, cause I just checked make sure my bend doors weren't broken and they aren't, but I also noticed the air flow isn't strong on the driver side either compared to the passenger side.
  14. MarcoFuc

    HAVC issues?

    So I tried that, I took it off, and it gets held down by the air flow and then firmly held top when it push up I can also hear the door flopping up and down when I move it as well. So I'm assuming the door bend isn't broken
  15. MarcoFuc

    HAVC issues?

    Gonna give that a go on my lunch break
  16. MarcoFuc

    HAVC issues?

    Thank you everyone for all your help trying to figure this otlut. Apparently it wasn't the Heater core, nor the bend door or the actuator it was the touch screen that I have I had a setting that turned on that I guess disabled the heat on my side.. I do now have hear after checking all the...
  17. MarcoFuc

    Bouncey ride help?

    I checked everything earlier and didn't see anything out of the ordinary so I'mma call tomorrow to have then do a balance and a rotation and see.
  18. MarcoFuc

    Bouncey ride help?

    That's what imma do tomorrow cause I checked everything back there and didn't see anything out of the ordinary
  19. MarcoFuc

    Bouncey ride help?

    So only going between 50-52 mph my truck gets real bouncey like really noticeable and bad it seems to be coming from the rear only. Once I go either just 1mph under or over that speed it disappears. I don't see any issues with springs or shocks. Has anyone experienced this? Or know what might be...
  20. MarcoFuc

    Long tube headers?

    Okay appericate it bro, mine is 2013.
  21. MarcoFuc

    Long tube headers?

    I have a couple questions regarding long tube headers and shorties, so my catalytic converter is failing on the driver side, it's got only a p0420 code no other code. I've changed out the sensors still came up. So I'm stuck in the middle between removing them and getting long tube headers or...
  22. MarcoFuc

    Po420 code, anyone have a idea?

    I do know I have a bolt messing cause it's stripped but that's been like that for months. And not that I have noticed no.
  23. MarcoFuc

    Po420 code, anyone have a idea?

    anyone have a idea what might be causing this? I was thinking o2 sensor but been reading and it says typically it would show a code for the sensor or a bad cat? Would this get triggered on if I have a exhuast leak?
  24. MarcoFuc

    Suggestions?

    On a cold start, there is no tapping or tick, only when the engine is about 190-200 “sometimes” it’s not all the time it makes the sound. Also goes away when I rev it alittle bit
  25. MarcoFuc

    Suggestions?

    Yah fram ive never used, my next oil change I might try the RP filter along with the 5/30 oil.

Latest posts

Staff online

Members online

... and 15 more.
Total: 1,546 (members: 65, guests: 1,481)
Robots: 1,460

Forum statistics

Threads
195,401
Posts
2,869,770
Members
156,071
Latest member
Beaniam

Share this page

Top