Search results

  1. R

    Wiper park position

    Bought a multifunction switch to try and same results. So I’m not sure where to go with this now
  2. R

    Wiper park position

    So replaced wiper motor and transmission. Everything was back to normal. Go to use the washer fluid sprayer to clean the windshield and the wipers wouldn’t stop. Had to turn them on then off. When ever they are on there is no different speeds like high, low, or intermittent. When I turn them off...
  3. R

    Wiper park position

    Yeah I replaced the motor last year and it worked great until yesterday. Might just get the whole assembly with linkage
  4. R

    Wiper park position

    2008 dodge ram 1500. Wiper motor was replaced last year. Everything has been fine until today. Wipers and controls function perfectly normal, just when turned off they always park in the middle of the windshield. Soon as turned on they travel the correct distance in both directions. My guess is...
  5. R

    Lost all power to everything

    So the other day I was installing a manual override switch for my flexalite fan I have installed. While installing it the switch shorted out, afterwards I noticed I had no power to anything at all in the truck anymore. No ignition, brake lights, acc power, completely totally dead. I tested power...
  6. R

    Turn signal fluctuates ambient air temp

    Both. And it only does it sometimes
  7. R

    Turn signal fluctuates ambient air temp

    Every time I turn on my turn signal the ambient air temp overhead display fluctuates from -10 to like 50. Soon as I turn off my turn signal it’s fine. Tried a new sensor since I had one available and didn’t do anything. Would this be a TIPM problem, or something else you guys might think of...
  8. R

    Can Bus diagnosing help please.

    TTT
  9. R

    Can Bus diagnosing help please.

    Hello everybody, I have a 2008 dodge ram 1500 4.7L that I’m trying to figure out diagnosing process. I’m getting codes U0019- Can B Bus that’s under ORC, B1629- Cargo lamp control circuit open under CCN-Cabin Compartment Node, U0019- Can B Bus under EOM Electronic Overhead Module, U0019- Can B...
  10. R

    Replacement catalytic converters

    I’m not 100% sure, but I’ve been rebuilding this truck that has been sitting for 3 years so it has all new O2 sensors, checked for vacuum leaks with both carb cleaner method and a smoke machine at the intake manifold, only smoke I get is from the small hole on the back of the Egr valve which I’m...
  11. R

    Replacement catalytic converters

    Keep getting p0420 code and now will stall out the truck and make the idle jump around. Guessing the cats are going bad, suggestions on replacement cats. I have a welder handy and pipe cutter. These are my freeze frames from when the code appeared if you guys have another take on it.
  12. R

    P0420 live data thoughts?

    I got P0420 on the way home today. Truck runs fine, has all brand new O2 sensors a little while ago. I took pictures of my live data, what are your thoughts on if the cats could be going bad or anything looks helpful with the data? I also notice bank1 sensors fuel trim was N/A but bank2 sensor 2...
  13. R

    Hole in throttle bodie

    While cleaning the throttle bodie the other day I noticed this hole. It doesn’t look like a factory made hole but it lines up with IAC, so I wasn’t sure if this hole has a purpose or if it got damaged at some point. Also wasn’t sure if it would effect anything performance wise or if I could get...
  14. R

    Gas cap light

    Gas cap light comes on instantly before even starting the truck. Looked for cracks in the lines and smelt for gas fumes and found nothing. Replace purge solenoid and leak detection pump, gas cap, and I’m still getting the gas cap light. No actual codes when I hook the scanner up. Any thoughts on...
  15. R

    Gas cap light on no other codes?

    I have the gas cap displayed on my dash but no codes pending or stored. Replaced the gas cap and purge solenoid and looked for cracks. Found nothing. Soon as I start the truck up instantly get gas cap displayed on the dash. Any ideas what else could cause this or does it need multiple good heat...
  16. R

    Ignition switch or something else bad?

    Yeah it’s on the column. I know I can replace it no problem. But wasn’t sure if there was a spring missing possibly in the actuator pin or if the ignition switch is what springs the key back to the run position
  17. R

    Wipers not working

    I picked up this truck with a dropped valve so no idea if the wipers were working before or not. But decided to give them a try and I got nothing on any settings. I also have low washer fluid light even though it’s full of those are some how tied together. I have squirters though. My question is...
  18. R

    High idle of 1500rpms

    Figured out the problem… some how the intake manifold sucked the oring seal off of the Egr tube. Don’t ask me how, but it did. I got this truck as a project so I’m not surprised that now as I move on I found out the wipers don’t work, and I get low washer fluid light even though it’s full. But...
  19. R

    High idle of 1500rpms

    Just replaced an O2 sensor and I’m no longer getting that code but I’m still getting a 1500rpm idle. I noticed on the scanner at “idle” the tp% 12.2 even though I’m not touching the pedal. Is that normal or could that be the cause of my problem and how would I diagnose it? Thanks
  20. R

    Ignition switch or something else bad?

    So I just picked up this truck and noticed when you turn the key forward it doesn’t return back to run from start on its own. Also there’s no distinguishing click that usually feel when it’s turn from off, to run, to start. I already replaced the tumbler and that wasn’t it. Does anybody know if...
    • RamRod302
    • Thread
    • actuator ignition ignition pin actuator switch tumbler
    • Replies: 3
    • Forum: Interior
  21. R

    High idle of 1500rpms

    I haven’t touched any of the O2 sensors. I got the truck for free cause of dropped valve and put new heads, injectors, plugs, seals, chain and tensioner kit, oil pump, to hopefully get a good running truck. I ordered all 4 just cause it’s been sitting and it was $60 for all 4 from rockauto
  22. R

    High idle of 1500rpms

    Ok update. The idle started to come down to 1000-1200 then I got the lightning bolt on the dash and a rough surging idle. Only code was for the 02 sensor still. Thoughts or ideas on what or where to start on diagnosis?
  23. R

    High idle of 1500rpms

    Ok thanks. Does anybody have any thoughts on the pcm needing to relearn the throttle body since it’s drive by wire? I’ve read different ways to “reset” everything
  24. R

    Possible vacuum leak?

    I have the 2008 newer 4.7. So I don’t have anything on my oil filler neck. Just the egr tube, vacuum line for the evap or purge, vacuum line for brake booster, and line on the back that goes to the pcv valve
  25. R

    Possible vacuum leak?

    Which hose are you referring to?

Latest posts

Staff online

Members online

Total: 1,270 (members: 50, guests: 1,220)
Robots: 1,676

Forum statistics

Threads
195,459
Posts
2,870,525
Members
156,168
Latest member
alhk

Share this page

Top