Search results

  1. C

    Anyone recognize nerf bar pad symbol?

    Maxmate https://www.amazon.com/MaxMate-2009-2018-2010-2019-Stainless-Mounting/dp/B00EP3PUV2
  2. C

    Need some help Transfer Case Control Module

    Update: So I am assuming I temp fixed my issue... Double checked all fuses again and low and behold F77 was blown.. so replaced it, cleared all codes with my scanner.. re-ran and it still gave same code... Went under passenger dash and grabbed all wires on the module, checked them again to...
  3. C

    Need some help Transfer Case Control Module

    Thanks. I had seen that before, good write up. I think my problem is there is a wiring issue or power issue going on. At a minimum from everything I have read if any of the components had failed I would see a service 4wd light or warning. It's like my entire system is dead and seen the 2011 had...
  4. C

    Need some help Transfer Case Control Module

    Anyone by chance have the wiring diagram for where it comes out the firewall on passenger side near the ECM.. see someone before me was using a test poker to check for power on some wires and curious if I need to start here.
  5. C

    Need some help Transfer Case Control Module

    My 2014 Sport wont go into 4wd. no lights on the selector, no service 4wd or nothing. My scanner shows U0102-00 which is Lost Communication with Transfer Case Control Module. I am stumped on what the issue is. Things I have tried. Replaced the actuator on the TC Replaced the dash selector...
  6. C

    Radio screen Blank

    UPDATE: Fixed mine... Turned out it was the HVAC Module going bad. Replaced it with a new one and radio works like it should, no more black screen!
  7. C

    Radio screen Blank

    Also curious if anyone has a fix. I replaced mine because my last was always black screen... I plugged in new one and it worked long enough for me to put the code in.. on restart the next morning, it's now black as well. Tried the smaller 5" radio out of my other 2014 and it's black.. plugging...
  8. C

    Front Diff/Carrier question

    Was just talking to my friend about this.. Told him I did not think it would hurt anything driving around without the front Diff parts while I source the pieces for the swap. Thanks for the info and reassurance that I can in fact remove it and use it.
  9. C

    Front Diff/Carrier question

    Was doing 45 on a State Rd... night time, tree was down(good size tree at that), didn't see it and whap.... Did not blow air bags, did not bend frame, just the inner fender closure was bent as seen in picture. Broke lower control arm, tie-rod end bent, CV axle separated, front diff bracket and...
  10. C

    Front Diff/Carrier question

    Yea, may wait on doing that mod.. Quite a bit of sourcing and downtime to go from New to Old after reading.. need my rig back sooner than later.
  11. C

    Front Diff/Carrier question

    Oh... never looked into that mod, didn't know it was a thing. Will have to do some searching on this as 3rd gen Diff/Carrier are pretty cheap it seems.
  12. C

    Front Diff/Carrier question

    Long story short, ran over a tree that fell in front of me, and my 3.92 front Diff/Carrier mounting bracket broke as in the picture below.. I "think" it can be welded easily enough, but in case it can't my question is, are all the Diff/Carrier housing the same size? The 3.92's are very...
  13. C

    Front fascia wiring harness help

    So bought my buddies truck that was wrecked, have it close to being redone... I had to purchase an entire front fascia wiring harness(headlamp harness) as the original was shredded from the wreck. I have the old out and the new one in. So far I have the headlights, fog lights, connector to AC...
  14. C

    Ready Lift SST 4"

    So your suggesting that if anyone has this kit they can't replace any other factory part ever? The lower control arms I put on where factory replacements. So were the end links and sway bar bushings and tie rod ends. The LCA has the ball joint on it and mine needed replaced which is why I did...
  15. C

    Ready Lift SST 4"

    2014 Ram 1500. I installed the ready lift 4" kit.. anyone else have any experience with this kit? After installing I feel my truck wonders all over the place. Hard to drive it at this point.. my wife drove for less than 2 miles and pulled over and called it dangerous. I put new Lower control...
  16. C

    Wheel Fitment in 4" lift

    So is the -44 further out from body? I have the ready lift 4" and I am running 35x12.5x20 fuel wheels with no rubbing. Granted, my wheels only stick out about 2" from body or 2" past stock 20's. Not sure what the backspace and offset on my rims are I got them used from a buddy.
  17. C

    EVIC Issue

    Seen a few people have this issue but no one has really solved it from what I have read... Seems centered around full brightness. I do not believe its loose fuses(even though I pushed all in) or the dimmer switch as it does not do it with my other EVIC only with the one i pulled from Donor truck...
  18. C

    Have a donor truck and have a few questions..

    Thanks for the info bud!
  19. C

    Have a donor truck and have a few questions..

    Hey all...owned rams for past 25 years, read the forums alot but just joined and looking for a little advice/help. 14 Ram 1500 SLT - Donor truck 14 Ram 1500 Sport Like many others I am doing the 5" to 8.4 VP3 NA. I bought a donor vehicle and want to take advantage of using as much of it as...
  20. C

    Ra3 to Ra4 Upgrade Question

    I am doing this same upgrade and I can offer a little help but still have questions myself. 1. I got my code from Ebay. Paid the 19.99 and I had the code in 5 minutes and put it in, it said the system would restart as it cleared off existing uconnect account. I came up fine, so I did not have...

Latest posts

Members online

... and 30 more.
Total: 1,386 (members: 80, guests: 1,306)
Robots: 1,855

Forum statistics

Threads
195,596
Posts
2,872,323
Members
156,401
Latest member
jesmich

Share this page

Top