Driver side control arm has a whole lot of slop in it. I'm trying to figure out exactly what I need to replace in order to get it firm again. https://vimeo.com/194376064
Sent from my HTC One_M8 using Tapatalk
wondering why my compressor turns on and then off when i ONLY have my heat on. Rather it be on vent/floor or just floor (i think just floor). But regardless, why does it cycle when i only have heat on and no defrost. Am i tearing something up cause i just put an entire new ac system in...
Gathered a bunch of old stereo equipment from previous cars and would like to put them to use.
Can this H/U be attached to the crossover below
pioneer super tuner 3d (only has single rca setup)
truck specs:
99 4x4 ram 1500 w/5.9 engine
9.25 chrysler rear end w/ 3.92 g-ratio
"][/URL]
"][/URL]
issue:
rear has blown
General questions:
is 3.92 g-ratio and 31's a suitable match.
will a 94 ram 3500 VAN rear with 3.9 work with my truck?
and are the suspension parts in...
Truck is a 99 4x4 5.9 single cab short bed. Just purchased it in December and the rear end went out on me on a trip going from GA to Indiana. I was cruising at 70 with a 6x12 double axle uhaul that had about 3k total weight. when the pinion bearing just gave out. Now that's I took the rear...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.