Search results
-
T
PO440 and PO441 rough idle
I have an 03 ram 4.7 truck with a rough idle and it seems to be only when the truck gets warm. I have had a po440 and a po441 code. I've recently changed the fuel cap and canister purge solenoid and it fixed my problem for a couple weeks. I've replaced a couple old hoses and I'm just running out...- tdela
- Thread
- Replies: 0
- Forum: General Discussions
-
T
Blower motor help
Has anyone had to buy this connector? Everyone including the dealer is trying to sell me the 4 prong one that plugs into the blower resistor. Attached pictures show this one plugs into the blower motor and is a 2 prong 2 wire.- tdela
- Thread
- Replies: 0
- Forum: Engine & Performance
-
T
What shocks are you running?
Let me know on the Bilstein 4600s they are one of my options -
T
What shocks are you running?
I purchased some NAPA Reflex shocks about 6 months ago (supposed to be monroe or compare to them) at $58 a shock I hoped they wouldn't suck so bad. Super bouncy and already feel like my stock shocks when they had 120k miles on them.. What are you guys running? The truck i'm running them on... -
T
Aftermarket Headlamps
Both of those are nice. Loving the looks of the projectors. What's it like to wire them in? -
T
Aftermarket Headlamps
Post up pictures of your aftermarket headlamps! Purchased some tinted ones off ebay.. love the look, hate the visibility at night. I'd like to get some ideas for some others. -
T
Truck dings randomly
This happened to me and nearly drove me insane.. Mine ended up being the tail light circuit board. Took both taillight assemblies out and checked the 3 bulbs on each one. Where one of the bulbs clicked into the circuit board was loose and wasn't allowing full contact for the bulb. Check...- tdela
- Post #4
- Forum: Audio & Electronics
-
T
4.7L owners I would like to know how you are doing in regards to MPG
I have an 03 4.7 with 120k miles 19-20 highway mpg and 14-15 in town Had issues with gas mileage right after I hit 100k changed plugs and O2 sensors and it went back up after that- tdela
- Post #21
- Forum: Engine & Performance
-
T
Any recommendations on loaded sub enclosures?
I've been looking at several loaded sub enclosures with an amp. I'm not into the shaking every car and house around me within 2 miles sound.. Just some bass to shake my side mirrors. I've looked into bazooka tubes.. seem big to be going in a single cab and the Kenwoods don't seem to...- tdela
- Thread
- Replies: 1
- Forum: Audio & Electronics
-
T
4.7 belt tensioner keeps going bad?
I have an 03 4.7 ram. I have bought THREE belt tensioners from napa and they keep going bad. All 3 times they were put on by different shops. This last time has lasted longer than most.. now i'm back to the squealing and shaky tensioner.. has anyone else had this issue? should I spend the... -
T
Coolant issues after flush
Finally gave in and took it to a shop. Come to find out my trusty new thermostat was defective.. Guy at shop said there is a way to run a vacuum when filling the cooling system on these trucks. No issues since it was fixed on Monday -
T
Coolant issues after flush
I appreciate it JPT. Did it your way and while running and can see some small bubbles every so often. This system is a nightmare to bleed! -
T
Coolant issues after flush
Flushed system and changed hoses and thermostat on 03 ram 4.7 Followed instructions on how to use bleeder valve to properly bleed the system Now the gauge wont go up to the half way mark of normal operating temperature.. When I floor it it shows to actually get cooler? What is going on? -
T
blacked out grille and headlights
Still not sure if I like it..- tdela
- Thread
- Replies: 4
- Forum: Member Trucks
-
T
Busy Friday night
Craigslist. Took me months to come across a decent one- tdela
- Post #5
- Forum: Member Trucks
-
T
Busy Friday night
Finally getting things done to the truck.. Installed drop shackles, removed overload spring, and put on new shocks while I was at it. Replaced my dented up front and rear bumper. Sent from my SGH-T999 using Tapatalk- tdela
- Thread
- Replies: 7
- Forum: Member Trucks
-
T
Bumper question
May be a dumb question but are the 1500, 2500, 3500 bumpers all the same mounting wise? Found a good deal on a complete front bumper with fog lights and everything. Wanted to make sure before I buy Sent from my SGH-T999 using Tapatalk -
T
girl in a mopar world
Always have to stand in front of a Chevy.. they are always broke down Sent from my SGH-T999 using Tapatalk- tdela
- Post #20
- Forum: Introduction
-
T
girl in a mopar world
I figured I should introduce myself to the RamForum community before I start asking tons of questions! I am from southeast texas born and raised. I'm not your typical girl.. from the time I was able to walk I was carrying around wrenches and always taking things a part. I am ASE certified...- tdela
- Thread
- Replies: 26
- Forum: Introduction
-
T
Faulty tensioner or another problem?
I was told it is a gates part, the warranty information I received has a gates e-mail on it.- tdela
- Post #3
- Forum: Engine & Performance
-
T
Faulty tensioner or another problem?
I replaced my belt, belt tensioner, and idler pulley at 110k miles on my 03 4.7 ram. Tomorrow will be the third time I have warrantied the tensioner from napa because the spring part in the middle keeps breaking causing the tensioner to shake and make the belt squeal until it is at a high enough...- tdela
- Thread
- Replies: 2
- Forum: Engine & Performance
-
T
Tuner for 4.7?
I appreciate the help. Seems like these trucks have no mid range power- tdela
- Post #9
- Forum: Engine & Performance
-
T
Biggest size tire on stock 20s
I have gone through the forum for days now and have not found a thread to answer my question Truck is stock height '03 and shackles are ordered from summit. What is the biggest tire I can run with the truck on the stock 20 rim? I am currently running a 275/60r20 and was wondering if there...
