Do a search on toe settings. The factory spec is pretty severe. Thuren lifts recommend different settings. Working great on my 2014 2500 so far.
Sent from my SM-G970U using Tapatalk
I ordered a set from Amazon and they work fine. Only problem is the panic button is a lot easier to hit for some reason.
Sent from my SM-G970U using Tapatalk
Anyone ever look at how the wiring harness in your truck is made? Its crimped. So I usually go with a good crimp tool and quality/ correct size connectors. I also have a quality soldering iron I use in certain situations.
Thanks for the schematics. All fuses are good. I have the 12v power supply and turn/brake signals at the 4 way and 7 way plugs. All the plugs under the truck look good. No corrosion and pluged in good. Everything worked fine last fall. Went to take the boat in for service and no running lights...
2014 2500 tradesman. I have no power to my trailer plugs for trailer running lights. All fuses have been checked with a meter and are good. Harness is seated properly at rear of plug. I have looked at all plugs in the harness from the engine compartment to the bumper. Haven't really looked at...
I was having problems with my remotes and replaced the rubber inlays. They both work great now. They were pretty cheap on amazon.
Sent from my SM-G950U using Tapatalk
The cap I use for deer hunting on my 2004 also fits my 2014. I had to modify the hatch on the back to clear the tail gate.
Sent from my SM-G950U using Tapatalk
I recently had this problem. It turned out to be a bad socket. Broken contact. If I remember correctly it was less than $20 from the dealer and just plugs in.
Sent from my SM-G950U using Tapatalk
Yes. Lifting the rear will have a very very minor effect on your caster settings. It shouldn't affect anything else as far as tire wear goes.
Sent from my SM-G935V using Tapatalk
Look at the sticker on the drivers door. In the lower right it should say paint followed by the three letter paint code.
Sent from my SM-G935V using Tapatalk
I did (well actually my wife did) simular damage to my 04 and had to have a frame shop get the bracket back in its proper place. They said it was a strong area and not an easy pull. I would think once you get it back where it needs to be, a little welding and bracing and you should be good to go.
Just picked up a new aftermarket chrome fog light bumper for $100 off craigslist!
Has one small blemish in the chrome down low. Now to get the lights and wiring ordered.
Sent from my VS985 4G using Tapatalk
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.