Search results

  1. Jimmy68

    Need to know, quickly. Steering linkage swap.

    6hr round trip. It's a beautiful thing.
  2. Jimmy68

    Need to know, quickly. Steering linkage swap.

    Have a T linkage from an 08 3500. $50 if I go get it. Good swap for my 01 1500 Y linkage?
  3. Jimmy68

    Alignment angles

    Watching. Intently. I too need to know.
  4. Jimmy68

    Merry Christmas

    That is my wonderful electric over hydraulic scissor lift. 6500Lb lift. Can lift my 01 Ram ext cab with 318 no problem. Can lift it about 4ft. Sure makes the diff swap nice. Slid diff under, lower truck, bolt diff and lift truck back up.
  5. Jimmy68

    Merry Christmas

    So Thursday was my last day before Holiday's. Off till Jan 2. On the way home my D44 is making a racket. Get home and pull cover. Well that's done. Cross shaft came out and took out pinion. So.... parts. Hey, that D60 in the corner? Yup. If I'm huckin money away it may as well be a 60. Tear out...
  6. Jimmy68

    Merry Christmas

    To all
  7. Jimmy68

    NP231D to NP241DLD swap

    Fihured out may vacuum leak. Zip tied the line to the t-case as I have the CAD locked already. Heater doesn't shuffle around anymore. Going to get new vac lines and replace the switch and CAD. Get it all working again as it should. But for now I have 4x4.
  8. Jimmy68

    NP231D to NP241DLD swap

    Very well. This T-case is good. The oil out of my old 231 was almost black and had a real nice silver swirl in it. Lol.
  9. Jimmy68

    NP231D to NP241DLD swap

    Well, T-case is out of my 01 1500. Have an old t-case out of a 94 2500. Driveshaft fits. Input splines the same. Length the same. Damn input on the 241 is 1 1/2" long and the 231 is 3/4". Having a smoke and a coffee. Splines are long enough, I'm going to cut the shaft down.
  10. Jimmy68

    Rumbling noise

    U-joint maybe.
  11. Jimmy68

    Speedi sleeve

    Ahh, good times. Good times.
  12. Jimmy68

    Speedi sleeve

    Can't find a used axle around here easy enough so going to put a speedi sleeve on my right axle (2001 dana 44). Without taking my truck apart till I have the sleeve is 1.6" correct for the seal surface? Anybody know?
  13. Jimmy68

    Transfer case swap

    Ya. It's cool. I'll figure it out later. Lost shift on the fly now. Just grinds. Gotta stop to engage the T-case. Don't matter anyway as the front diff gave up locking up anyway. Got a set of 60's to rebuild and install this summer and do a T-case swap.
  14. Jimmy68

    Sea Foam

    I use it. I like it. Motorcycles to lawn mowers to trucks. Few examples: 80 Yamaha XS1100 with bad mix match carbs (4) but I had a parts bike. Carbs were attached to the engine but no air cleaner and sitting outside for several years. Pulled them off and sprayed them down with some carb clean...
  15. Jimmy68

    Transfer case swap

    I guess nobody knows. Maybe I'll post the answer this summer when I swap it.
  16. Jimmy68

    8bolt hub swap?

    Just like days of old. Dana 44 came 5 lug or 8 lug. But rear needed a swap. With the second Gen it is fairly easy to swap both diffs and if you look long enough you will find cheap 60's. Paid $300 for my pair.
  17. Jimmy68

    Transfer case swap

    I have an 01 1500 auto with a 2001-98 23 spline input, 32 spline rear slip, w/o speedo hole, manual shift, flat circular front output yoke. .840 exposed input. A/T NP231D. I have a T-case from a 94 2500 auto and I have not dug out the shed to access the T-case yet but it could be one of two...
  18. Jimmy68

    I've bad ideas. Front Dana 60

    Ok. I finally got D60's for front and rear. $300 for the pair. 1998's. I have a Ford 60 and pulled it apart. Year.. I can't remember off hand. It's a leaf sprung one. Anyway, knuckles fit my Dodge 60 so I'm going to start swapping parts to get the Ford stuff on and have locking hubs. Dual...
  19. Jimmy68

    Next question. Diffs.

    Nice. 60/60. All I need. My front 44 is leaking and growling and for $300 I can grab a pair of 60's.
  20. Jimmy68

    Next question. Diffs.

    Looking at a pair of diffs from a 98 2500. Owner says front and rear Dana 60's. Thought rear was a 70. Did gas 2500's have a 60 rear in 98?
  21. Jimmy68

    No Bus/No O/D

    Old one back in and truck runs the same as it did before the swap. Just like the piece of shit it always has been. Lol.
  22. Jimmy68

    No Bus/No O/D

    How would it affect trans cooling?
  23. Jimmy68

    No Bus/No O/D

    Just took a drive. Trans temp light came on. Gotta swap back.
  24. Jimmy68

    No Bus/No O/D

    Swapped my comp from my 318 one to a 360 one. Do I have to go get it flashed now or something? Going to reinstall my 318 one.
  25. Jimmy68

    Tagged a moose :(

    Definitely looks like shit. My wife tagged a Moose.

Latest posts

Staff online

Members online

... and 12 more.
Total: 1,446 (members: 62, guests: 1,384)
Robots: 1,568

Forum statistics

Threads
195,592
Posts
2,872,219
Members
156,379
Latest member
Jass Dhaliwal

Share this page

Top