Search results

  1. Mop

    which rear end differential gear oil to use?????

    If it's Limited SLip, add Mopar Friction Modifier, before the new gear oil!
  2. Mop

    01 Ram Clicking under dash, passenger side

    The Actuator can be removed without removing the dash. It's close to the floor, not the most fun thing to do. I pulled my carpet away from the duct. I made a straight slit in the rubber flooring for room. Using a tiny screwdriver, and bring it down. The plastic hinge is probably crumbled. Order...
  3. Mop

    Tail Light Issue

    There is a ground wire in the front of the bed, on the passenger side. I believe it's 10mm, if I can remember right. Could that be the one you had forgotten?
  4. Mop

    Keeping steering stabilizer with Redhead steering gear?

    I believe Redhead sells a stabilizer as well, which leads me to believe it will work with it. I've read too many bad things about them, and bought a Blue Top. It's well built, and the stabilizer works with it.
  5. Mop

    stutteing

    ABS light is the rear speed sensor, most likely. Stuttering could be O2 sensors, or ignition. The fuel level could be the pump assembly itself, or possible electrical issue. Check those first.
  6. Mop

    T-Type steering. I know this has been talked about, but I need help!

    Since yours is a 94, your best bet is to buy 1999 Ram 2500HD rods. They bolt right in. Factory upgrade setup.
  7. Mop

    LMC Steering Shaft

    UPDATE: the shaft arrived. For anyone considering this shaft, it is NOT a Borgeson. Looks like one, though. It does NOT have set screws, it closes around the gear box, and steering shaft, and tightens with Allen-head screws, similar to the way a stock replacement attaches with bolts. It is...
  8. Mop

    LMC Steering Shaft

    With all the steering issues, I'm surprised no one has tried the LMC shaft. I ordered one, I'll update on whether or not it's worth it.
  9. Mop

    LMC Steering Shaft

    Hi all, My search didn't find what I was looking for. My '99 Sport has a loose UV joint in the steering shaft. I know LMC has a "factory" replacement, and a heavy duty one. They don't show what company makes the heavy duty one. I asked them. I want to make sure it's not a Borgeson. Has...
  10. Mop

    Belt (I Think) Squeal

    Yes, check all pulleys, could be their bearings, also.
  11. Mop

    Vacuum Problems

    Besides the lines under the hood, have you run new lines to the back of the climate controls? Check that, and the main connection behind the controls. Something in the lines could be cracked, but hidden.
  12. Mop

    Vacuum Reservoir location

    Just checking to see if you ran rubber to the back of the climate control, and those lines are attached below the dashboard.
  13. Mop

    Curise Control and Vent doors, possible vacume leak?

    The check valve is on the passenger side, near the firewall. You'll see thin plastic lines come out of the intake manifold, and into the firewall. To fix everything permanently, buy 3mm inlet diameter rubber tubing, clip the factory plastic lines, and squeeze the rubber onto those lines. Bypass...
  14. Mop

    Transmission rebuild

    What are the problems? Sometimes, simple sensor replacements, adjustments, etc. can fix everything. If you're dedicated to a rebuild, TransGo has a full kit. A few guys have even ordered the 47RE kit, (as opposed to 46RE) for a stronger rebuild. GM pressure sensor, Borg Warner solenoid, there...
  15. Mop

    2ND GEN RAM1500 NO HOT AIR BLOWI

    See above. The blend door actuator has a plastic hinge that crumbles over time. Take it down, if it's bad, buy a Heater Treater. Follow directions, and it's done. If it's the vent doors, it could be a simple vacuum leak, and they aren't closing completely. Buy 3mm rubber tubing. Bypass the...
  16. Mop

    Rust prevention

    Around November, I spray Fluid Film all over the visible parts, and inside small areas. I have ketchup squeeze bottles full of tranny fluid and white Vinegar. I shoot those inside the frame rails, hidden areas, inside doors, etc. Everything adheres to the metal, and repels the bad stuff. Do it...
  17. Mop

    Fog Light Suggestions for 1995 Dodge Ram 2500

    Keep in mind, when searching headlights, you have single-type. One bulb for low and high beams. Sport Package have 4 lights, separate low and high. Be careful not to mix up your search.
  18. Mop

    Sport Off Road light mounting options

    I have a Sport, and have been looking at off-road lights for a while. I won't cut into mine, either. One of the best alternatives I've found, are the Oznium Ultra-Thin Bar. Multiple colors, fits behind the grille, LED for less power pull. You can link multiple bars together. I don't have them...
  19. Mop

    Starting my build.

    Nothing better than this kind of build! You can roll anywhere, any time!
  20. Mop

    "Regular" Track Bar

    That has been on my mind. Strange thing, I not only rotated everything, but also, put different tires on it. Same thing. It feels like it's focused on the driver's side wheel. This is why that Track Bar is on my mind. I have a feeling the tie rod end of it was bad from the factory. I'll find out...
  21. Mop

    "Regular" Track Bar

    I wouldn't take it personally. He actually told me I can use his shop any time I want to, he trusts me. If he doesn't trust me using anything in there, he would let me know. I'd have no problem having him do the work, and paying him. He knows his stuff.
  22. Mop

    Starting my build.

    Nice. You might want to consider the 2nd battery being mounted somewhere underneath. Easier to get to, and it will distribute a little weight elsewhere.
  23. Mop

    roof paint

    I agree above. If you go rattle, 2k clear is a must. I've done some small areas on my truck, (due to clearcoat fade) and you can't tell until you look closely. Prep is important. Sand the clear, clean, lay the color, then lay a tack clear coat, then go heavier until it looks "wet." Let it...
  24. Mop

    "Regular" Track Bar

    My brother's friend owns a shop, I'm sure he has a dial indicator. I will ask him about it, thanks!
  25. Mop

    "Regular" Track Bar

    Not dumb. An alignment was done around 2 years ago, when I replaced parts. They did a printout, and they showed me the adjustments they did. As far as parts, all tie rods (I made the mistake of buying Y-steering, but I now have new T-steering from 1999 2500HD rods, and will go in), Track Bar...

Latest posts

Staff online

Members online

... and 11 more.
Total: 1,385 (members: 61, guests: 1,324)
Robots: 1,961

Forum statistics

Threads
195,613
Posts
2,872,571
Members
156,438
Latest member
Prorider17

Share this page

Top