Search results
-
Projector Headlights
I have non factory reflector headlights, bought some 4 light LEDs and they suck. Beam is all scattered because the reflectors have a hood which bounces the light back on the reflector part and so all he reflector parts scatter the light. I put a incandescent bulb in one and it is way cleaner... -
OverHeating, just started two days ago
I have a 98 with a 5.2. I recommend you make certain the radiator is completely full. The system is designed to flow some fluid to the reservoir when it is hot and suck it back in as it cools, controlled by the radiator cap, which I would change right away, it is cheap. The cap on the...- Kickkem
- Post #2
- Forum: Engine & Performance
-
99 ram 1500 front axle seal question
The March 2018 Petersen's 4 wheel mag had a tech article about this very thing. According to McGhee you need these and the part number is Spicer 36364. $4.99 per -
replaced almost everything, still no brakes
I have seen the situation where the calipers were on the wrong side and there was no way to bleed them since the bleed screws were down instead of up. Just a thought. -
2nd Gen Brake Issue - Weak Pedal
Make absolutely certain that the bleed screws on the front brakes are UP not down. If you reverse the calipers you will never bleed them. I have seen this more than once. Good luck!!- Kickkem
- Post #21
- Forum: General Discussion
-
Changed AT fluid, now won't shift
Keep in mind that when you change the Tranny fluid the new fluid cuts loose all kinds of crud which could plug the Valve Body. I would change it again or have it flushed, easier although not cheaper. I have had several friends who had the flush and then problems, but the second flush worked...- Kickkem
- Post #8
- Forum: General Discussion
-
New member need some knowledge.
Sorry, but if you have a 360 it would be a 5.7 liter. The 318 is a 5.2.- Kickkem
- Post #10
- Forum: General Discussion
-
New member need some knowledge.
Welcome to the forum and to the world of Ram trucks. Every previous post has merit and you should consider/check them all. I just wanted to point out that checking the track bar (which is the thick rod attached higher up on the frame on the drivers side and lower down on the axle on the other...- Kickkem
- Post #9
- Forum: General Discussion
