Search results
-
200,000 miles today
Ladies and gentlemen......I may or may not be breaking protocol here, so allow me to apologize in advance if I am I would just like to take this opportunity to publicly acknowledge my truck effortlessly and gracefully flipping 200,000 miles today It's taken me to 49 states, a few countries...- Eric1976
- Thread
- Replies: 14
- Forum: General Discussions
-
Transmission temperature
Yessssssss....that’s it! Thank you so much! Man, I thought I was gonna be the unanimous winner for the hero of the day award for rescuing a couple of feral kittens stuck in a storm drain but that award definitely goes to you! It’s been driving me crazy for a few years now! I’m sure it’s in the...- Eric1976
- Post #3
- Forum: General Discussions
-
Transmission temperature
In the past I’ve been able to access the transmission temperature using the controls on the steering wheel but it’s always been by accident. Can someone tell me how I can get to that?- Eric1976
- Thread
- Replies: 2
- Forum: General Discussions
-
Mouse getting into my cab.
I had a Hyundai Santa Fe and over the course of about 3 weeks - a very painstakingly frustrating 3 weeks - I ended up putting gorilla duct tape over the large enough holes for a mouse to get through “vents” where the windshield wipers are. It wasn’t because I eliminated all other options, it’s... -
Engine accessory life expectancy.
2015 Ram 2500, 5.7, 181,000 miles....replaced both front wheel bearings about 10,000 miles ago. A couple of u-joints, just started using the RedLine oil a few oil changes ago which reduces the ticky-tick. Replaced the battery summer of 2018. That’s about it. Mostly highway/cross country driving...- Eric1976
- Post #10
- Forum: General Discussions
-
Blower Motor Potentially Going Out? Unusual Fan Noise
Ugh......I just listened to the YouTube link you included on this thread and my truck was making that exact same noise. Emphasis on WAS because my blower motor isn’t doing anything now I hate that you had to go through it but I appreciate all the information you provided on this thread -
What has been you're Ram experiences
2015 2500 5.7 175,000 miles Purchased truck with 12,000 miles. I’ve had to replace drivers side wheel bearing at 160,000 miles, a couple of u-joints at 170,000 miles. Replaced drive belt at 140,000. Fixed the third brake light gasket.......and that’s pretty much it. I just put gas in it and...- Eric1976
- Post #92
- Forum: General Discussions
-
Pedal Commander help
I’ve had my pedal commander for two years and never had a problem with it..........and now it sets off the engine light and goes into limp mode more often than I’d like it to It’s the only modification I’ve done to my truck and I really dig it Driving my truck with the pedal commander is like...- Eric1976
- Thread
- Replies: 60
- Forum: General Discussions
-
Front hub life span
Just replaced drivers side front wheel bearing at 160,000 miles. Mostly highway driving, but conservatively. However, I do have a good habit for going down bad, rural roads ♂️ I’ve replaced a wheel bearing on just about every vehicle I’ve owned. Once the humming got louder on any of those...- Eric1976
- Post #21
- Forum: General Discussions
-
POWER RUNNING BOARDS
I’ve driven through the Sierra Nevada mountains during several snow storms.....was in northern Michigan last winter during a few ice storms, parked overnight in freezing temperatures and never had a problem with my running boards not working properly......that I can recall. It seems like they... -
POWER RUNNING BOARDS
Hi, welcome to the forum I have a 2015 2500 that I bought used and the previous owner installed the Amp Research running boards. I dig em’ I don’t usually care much about that stuff.....and I probably would’ve been fine with standard fixed running boards, but they kinda make me feel like a... -
Hello from Minnesota.
Hi Ben......welcome to the forum. I’m sure there’s many more knowledgeable people on this site than I am, but I’m happy to help out any way I can- Eric1976
- Post #2
- Forum: Introduction
-
Hello Everyone...New Member.....(kind of)
Hello everyone, I bought my Ram in December 2017 and joined this site soon after, but somehow I’m just getting around to introducing myself now ♂️ My dad worked for GM so that’s all we ever had growing up and I suppose my loyalty to the brand stems from that. The last two trucks I had were...- Eric1976
- Thread
- Replies: 10
- Forum: Introduction
