Search results

  1. E

    Radio interference stops when brake depressed.

    My wife says...that's all I'm good for. Oh, that and shoveling the driveway.
  2. E

    Radio interference stops when brake depressed.

    Perhaps I bond my grounds? Or do I ground my bonds? Crap. Thats another argument. Maybe we can discuss what oil is best? Crap, that won't be better. I got it. Which tire is best?
  3. E

    Interior squeak ***update*** fixed

    You can try polyethylene tape as well to put between two parts that are squeaking. I used some of this at various locations in the cab. it works well. https://www.amazon.com/WOD-Polyethylene-Transparent-Tape-Aggressive/dp/B07JF1RDWN
  4. E

    Radio interference stops when brake depressed.

    Well, I also have a 2012 Ram. Guess what...I have the same thing. It only seems to come through the front passenger door speaker. I thought it was the aftermarket radio, amp, etc - wasn't. After getting super duper shielded cables, moving them, different amp, etc, it is still there. I...
  5. E

    Blackstone - used oil analysis

    There are a few posts after this one (linked below) that have the analysis. It was the Castrol Edge; and the PUP is doing better than the Castrol (but the wear was fine with Castrol as well). FWIW - It was at 110k miles I switched to PUP from Castrol; I think I implied it was 100k earlier. My...
  6. E

    AC shuts off when idling in traffic

    I'll bet you that the active aero grill shutters are stuck closed. If you were to physcially remove them, I'd bet your temps drop dramatically.
  7. E

    Blackstone - used oil analysis

    I've been running M1 0w20 and M1 filters for the first 75k miles; switched to castrol 5w30 + MOS2 with SRT filters for about the next 25k miles, and running PUP 5w30 + MOS2 with Royal Pruple filters for about the last 30k miles. Somewhere in this thread about 3 (?) years ago...Burla compared...
  8. E

    Blackstone - used oil analysis

    Another from my Ram 1500 w/ 5.7. I forgot to do one last oil change - so the last comparables are from roughly a year ago.
  9. E

    BW 44-44 to BW 44-45 Swap

    Do you have the security bypass cable for the 2018+ trucks? I think it was 2018 when that was implemented on the Ram.
  10. E

    5th Gen Seats into a 4th Gen?

    I assume the same HSM is in the '13+ trucks as was the '09-'12 trucks.... I added pictures to my prior post. Basically, the outputs of the 4th gen HSM are ~+10vdc (low) and ~+12vdc (high). Take those outputs to the input of a PWM controller. On the 5th gen fans, cut the wire to the fan...
  11. E

    5th Gen Seats into a 4th Gen?

    Tell me about that Radio you've got....
  12. E

    5th Gen Seats into a 4th Gen?

    So, I got the cooled seats working. I used a PWM controller to make it work. The output from the 4th gen HSM goes to the PWM controller, and the output of the PWM controller goes to the 5th gen fans. I had to wire the fans directly to the PWM controller - since in the 5th gen, the fans have...
  13. E

    AC shuts off when idling in traffic

    Does your truck have the aero grille? The one with the flaps that close at highway speeds? If so, any chance they are 'stuck' closed? If your efan is working, that's the next thing I'd check.
  14. E

    I swapped Corsa for Borla Touring now that I have LT's, here is my take.

    I put a Borla resonator on my truck (I'm running the 24-in magnaflow), but had drone at the same RPM. The resonator really knocked down, but not eliminated, the drone. I'd say it's probably 70-80% reduced. https://www.summitracing.com/parts/bor-401343
  15. E

    8 speed swap

    The anticipation of your swap is awesome! I know you've talked about wanting to do it for a while, and now to see the pieces coming together...I'm excited for you!
  16. E

    8 speed swap

  17. E

    8 speed swap

    I wrapped the cooler lines over the top of the transmission, going reward (as you see in the pic) and then on the other side brought them to the front, and used heat insulating fiberglass. I'll grab a pic this evening on the other side for you.
  18. E

    8 speed swap

    I never installed the neutral bracket. Never felt the need, honestly. I actually used the location to install the transmission cooler thermostat. I think you'll be plenty fine without it if your new transmission doesn't come with it.
  19. E

    8 speed swap

    I have a 2019 1320 stock file - if your email is still the same as it was last year....the file is in your email now. Otherwise, shoot me a PM with your new email and I'll send it your way.
  20. E

    8 speed swap

    You're cruising! Nice work in the dial shifter grafting! It looks almost natural there, doesn't it?
  21. E

    8 speed swap

    I think I have a copy of the stock 1320 TCM file - I can check when I get home.
  22. E

    8 speed swap

    I had both in my truck. The traditional shifter (Challenger shifter) feels more 'normal' but I enjoyed the space that was created by the dial shifter. I had the dial shifter first....then swapped to the Challenger shifter. I still need to send my TCM to Russel to reprogram to enable the...
  23. E

    8 speed swap

    It may have been expensive today. But the real question you'll ask yourself is....why wasn't it like this from the beginning? My truck completely transformed with the 8spd. No joke. Went from 'looks nice, drives fine' to 'looks nice, drives amazing'. I will likely be selling my shifter...
  24. E

    Balance beads

    The OEM plugs on one of my toy cars are the Bosch +4. Does it matter? I dunno. Could be just Germans taking care of other German companies. But I do think the OEM chose it for a reason; even if it was only for a longer service interval (most likely).
  25. E

    Steering Column Opening Cover

    It will fit; EXCEPT around the ignition key; since the 2013 went to push button start (grey ring as you describe).
Top