Search results

  1. K

    Check engine light still on after replacing cap

    Had a misfire on cylinder 2 with the wife's Pacifica with the 3.6 Pentastar, forgot the specific code unfortunately, P0302 maybe, but I replaced the fuel injector and it ran smooth since. Replaced at around 34k, just over 60k now and no issues since replacement.
  2. K

    Finally, upgrading my factory audio (Keep it simple, stoopid!)

    Do you have any photos of the head unit installed?
  3. K

    Bleed down fuel rail

    The fuel rail does not need to be removed to replace the oil cooler. Leave it attached to the lower intake manifold and the whole assemble can be flipped upside down and moved to the driver side of the engine bay. You'll need to disconnect the electrical connectors from all 6 injectors and the...
  4. K

    Brake drag or bad alignment?

    Thanks everyone for their input. I was finally able to get it back in to check the alignment this morning and was sure to get a print out. Pretty alarming what the starting point was. Haven't driven the truck much, but so far it seems to track straight, although the steering wheel may be...
  5. K

    Brake drag or bad alignment?

    I had the alignment done as it has never been checked since I bought the truck new in 2018. The winter tires never wore right and would always scallop. I wondered if that was due to the winters being directional tires, so they only get rotated front to back as I have them mounted on a second...
  6. K

    Brake drag or bad alignment?

    Any tips on how to test this? With the truck running, I have pumped the brakes several times and then cracked the bleeder. Fluid did not squirt out with force, but dribbled out and there was no noticable reduction in the drag when spinning the wheel after. That seems to be the main indicator...
  7. K

    Brake drag or bad alignment?

    I forgot to add that I did measure with IR temp gun and after driving the left side was only 10 to 15 degrees hotter. Measured both sides where the pad makes contact bit close to the rotor hat as that was the hottest spot of the rotor on both sides. The temp difference seems minimal and was...
  8. K

    Brake drag or bad alignment?

    Hello, I'm looking for some insight from some more experienced individuals. I recently had my truck aligned and now it is pulling to the left. It did not pull previously, but felt like I had to constantly correct on the highway and my winter tires never wore right. Summer tires wore even for...
  9. K

    Sold

    Radio has been sold.
  10. K

    Sold

    I am selling my UAS radio which comes with CarPlay and Android Auto. Was removed from a low miles 2018 Ram. Screen is in excellent shape but does have one tiny scratch that is about 4 mil in length. I do have the VIN from donor but never got the unlock code as I never installed in my vehicle...
  11. K

    How to add remote start to 2017 Ram

    I shoved a wire into pin 11 on that connector and grounded to bolt by the ebrake pedal. This works but bypasses the safety feature of the hood latch which would break ground when the hood is open so you don't accidentally start truck with hood open. You can always undo your ground connection...
  12. K

    How to add remote start to 2017 Ram

    That is it. I could not see the purple wire with blue tracer so I unplugged the connector and verified pin 11 was not populated.
  13. K

    How to add remote start to 2017 Ram

    I'm in the middle of this process myself. I had wiring on the driver side of pcm connector for the hood latch but I had nothing in the passenger side of pcm connector or in pin 11 at BCM. I will now have to populate pin 11 at the BCM. I wonder if your wiring is setup like mine. 2018 1500 Express
  14. K

    Hood Latch Assy for the Remote Start Kit wiring question ...

    So I am trying to get oem remote start and I have done all the Alfa programming but I appear to not have anything pinned at #11 on the BCM connector. Is there a way to ground prior to that connection or do I need to pin a wire into #11 and run that to ground?
  15. K

    Synthetic Oil

    Haha it's less than 20f basically ever morning in the winter here. I had -12f as I was leaving the house today.
  16. K

    Synthetic Oil

    I was going to add if I just start the truck and drive I get less accumulation but for the sake of my drivetrain I have been letting truck idle up to about 120°f for coolant which is when the idle will drop below 1000 rpm to take off.
  17. K

    Synthetic Oil

    I don't have a hemi but the CC on my 3.6 will be full in 2 weeks. I drive maybe 300 miles in that time. My 5.3 Silverado was the same way in winter. I'm central VT for perspective. I get crazy amounts in winter henand t warmer months it goes back to a reasonable amount. Maybe would empty...
  18. K

    2018 RAM Security Module Bypass

    Looking to order a bypass harness but website says out of stock. Any idea when you may be able to make some more up? Thanks.
  19. K

    4 new TPMS sensors, 3" EVIC cluster low miles

    I do, PM incoming
  20. K

    Synthetic Oil

    Oddly enough that is something I have been doing if it is cooler in the AM, as it has been recently, and I am more in a rush and don't want to let the truck sit and warm up for a few minutes, I will let the idle settle from startup, shift to N for 10-15 seconds, then to D and it seems to...
  21. K

    Synthetic Oil

    What engine? I assume the 6.4 based on the 0w40 comment. I think most 6.4 guys are running 5w40. Redline says on the bottle not for engine break in - allow 2,000 miles. As far as warranty use your discretion, personally I have no fear about warranty issues regarding the oil I have used but...
  22. K

    Anyone have these? DV8 Bumpers

    Awesome to hear the quality is pretty good for the price point. I had seen a few others at this price range with less than satisfactory welds. I do have the single exit exhaust similar to the 2500s. Probably one reason I like most of the 2500 bumpers more as well since I don't want to have...
  23. K

    Anyone have these? DV8 Bumpers

    I've been looking at aftermarket bumpers myself and that dv8 rear for the 2500 is one of my favorites. Now I'm trying to figure out what is different for the 1500 to 2500 and if I will be able to mount it to my 1500 without too much modification. Looking forward to pictures and opinions after...
  24. K

    Synthetic Oil

    QSUD has been holding up great in the Pacifica. Engine has been quiet and happy, still getting good MPG even with the thicker oil haha. I know it is regarded well here and possibly for the price one of the best bang for the buck oils you could choose.
  25. K

    4 new TPMS sensors, 3" EVIC cluster low miles

    Sure do

Latest posts

Members online

Total: 309 (members: 9, guests: 300)
Robots: 1,050

Forum statistics

Threads
195,437
Posts
2,870,249
Members
156,135
Latest member
2023RamWarlock

Share this page

Top