Search results

  1. D

    How to remove a stuck CV axle shaft

    That worked for one side of mine. The other side wouldn't budge. I ended up coming to the conclusion that I would have to cut it off so I started the process. I was pretty close to cutting the bell housing off, because I was going really slow, and thought I would whack it a few more times with...
  2. D

    How to remove a stuck CV axle shaft

    I used a torch and heated up where the cv axle connects to the differential. I cut the metal band so i could remove 80% of the cv axle and just deal with the inner bell housing. I keep spinning it to get a good heat around it. Then used a hammer and hit it several time in an outward direction. I...
  3. D

    Brake caliper question

    I do that. My problem was getting thr caliper off from the rotors and pads. These little bumps on the back of the pads would damage the piston when I pryed off the caliper with a pry bar. Sent from my SM-N960U1 using Tapatalk
  4. D

    2012 Ram 1500 5.7 oil change

    I have a 2011 Ram 1500 and it won't come on until the recommended interval, which is 7500 miles between changes. The message appears on the information screen in the dash. You will need to Google how to reset the notification cause it is funky. Sent from my SM-N960U1 using Tapatalk
  5. D

    How to remove a stuck CV axle shaft

    Digging up an old thread but thank you. I bought a slide hammer with the big socket end that is supposed to make it easy to get off but so far no luck. May have to start cutting. Sent from my SM-N960U1 using Tapatalk
  6. D

    Brake caliper question

    Thats some nice, and expensive, brakes Sent from my SM-N960U1 using Tapatalk
  7. D

    Brake caliper question

    So use the wedge to drive it between the pad and rotor to compress the caliper? Sent from my SM-N960U1 using Tapatalk
  8. D

    Brake caliper question

    Thanks. Unfortunately it rips right through the actual pistons and destroys then. Sent from my SM-N960U1 using Tapatalk
  9. D

    Brake caliper question

    Fixed. Thanks. Sent from my SM-N960U1 using Tapatalk
  10. D

    Brake caliper question

    I wonder if anyone else has the happen to them but everytime I change my brakes and remove the caliper, the brake pads tears the crap our of my caliper piston. It has to do with two little bumps on the back of the pads and rip through the piston. I am sure I am doing something wrong since all I...
  11. D

    Need Help, thermostat swap

    Same with me. I had to change mine in 2011 Ram 1500 and I just pulled the housing off and let the fluid pour out. I didnt lose that much, unless you just dont want to make a mess. Sent from my SM-N960U1 using Tapatalk
  12. D

    Diff Gaskets?

    I am always a fan of using a gasket with RTV smeared on both sides. Sent from my SM-N960U1 using Tapatalk
  13. D

    Painted engine cover

    How many coats of silver you use? It looks damn good Have a link for the decals? Sent from my SM-N960U1 using Tapatalk
  14. D

    Painted engine cover

    Holy crap. I like it a lot. Since truck is red it would be nice to paint it red instead of your silver. What paint you use? I just had to replace my windshield washer sprayers and pulled down the heat fabric and spray painted it black because it looked old and dirty. Sent from my SM-N960U1...
  15. D

    Aftermarket transmission pan

    I just replaced my pan with a Dorman 265-870. I have a 2011 Ram 1500 4x4 so I needed that one. It also has a drain plug in it and it fit perfect. I used a gasket and a little rtv to seal it. I bought it on Ebay for $45 Sent from my SM-N960U1 using Tapatalk
  16. D

    Weird noise

    Ok. I will check this out the next time I have a nice day. Just bolts or are they welded to the floor pan? Sent from my SM-N960U1 using Tapatalk
  17. D

    Weird noise

    I just changed rotors and pads and at least one of the shields was rusted to hell and had rust holes in it. The wheel bearing has to come off to replace this if I remember. I might as well replace the bearing since it is off. Sent from my SM-N960U1 using Tapatalk
  18. D

    Weird noise

    Heat shield around the cat or is there more under there? Sent from my SM-N960U1 using Tapatalk
  19. D

    High pitched whining sounds from engine bay

    The only experience I have had with this is coolant in the system hissing and making noise after the vehicle is ran and then cooling off.
  20. D

    weird noise when coasting / slowing

    Did you get this resolved? I also have this weird kind of noise but my truck is much older than yours with many more miles.
  21. D

    Weird noise

    You know the sound you hear echoing back at you as you drive down the road close to a guard-rail or a hill? Most times you cannot hear it yourself since you are inside of the truck but every so often you get the echo how what your truck sounds like. This is what I am hearing and I don't like it...
  22. D

    Digital speedo

    I am interested in this as well. I have an '11 1500 and thought about buying one of those cheap HUD displays to reflect it off my front windshield. Sent from my SM-N960U1 using Tapatalk
  23. D

    Water Leak

    I have had my 3rd brake light leak. I took it off and used clear silicone to seal it. Hasn't leaked since. Sent from my SM-G955U using Tapatalk
  24. D

    Disappearing Instrument Readings

    It happened to me and was blank first days. Only the backlights would give on, no display info. Never figured out what was wrong, it just started working a week later and stayed working. I have 2011 1500 SLT Big Horn Sent from my SM-G955U using Tapatalk
  25. D

    Console information screen blank

    But now my information screen won't display anything. And no, I don't have it turned off. Sent from my SM-G955U using Tapatalk

Latest posts

Members online

... and 20 more.
Total: 1,413 (members: 70, guests: 1,343)
Robots: 1,756

Forum statistics

Threads
195,462
Posts
2,870,549
Members
156,170
Latest member
KingBDS

Share this page

Top