Search results

  1. H

    oil filter change hint

    You can see the thing I was talking about in this image here.
  2. H

    What did you do to your Gen3 today?

    Somewhere during the ride there the cluster said LoWASH and sure enough it was empty. I had been using it on the trip. On the way back, it started to snow so I picked up some windshield fluid with de-icer. Filled the tank and nothing came out of the nozzles. I pulled the hose off the pump and...
  3. H

    What did you do to your Gen3 today?

    I went on a 1300 mile round trip. I noticed that my washer fluid isn't coming out when I pressed the button and I am not sure why yet, sure needed it during the snow areas.
  4. H

    Cylinder #1 misfire (P0301) and CEL, but only at 4500/5000 rpm and above

    bad o2 sensor can cause misfire. Also, I broke the coil on plug boot and didn't replace them immediately, also causes a misfire.
  5. H

    oil filter change hint

    Does your truck not have the small black "funnel" device that is under the filter? When I perform a filter swap, I crack the filter and the oil falls down onto a ramp and that runs down further in front of the truck where you can actually put a catch pan. I tried to google for images but no luck.
  6. H

    New Software Comments, Suggestions & Questions

    Anyone else not really being notified of replies? I have my notification settings on but rarely does the forum notify me via the red bell on the top right of the page.
  7. H

    P0300, P0152

    Youre the third person to say that.
  8. H

    P0300, P0152

    I went to the parts yard and took two o2 sensors home. Truck is doing fine other than an exhaust leak code which I will say is because the crush washers on those sensors are already used. Ill buy 4 new sensors soon as I can.
  9. H

    P0300, P0152

    I checked the part number and they are OEM Mopars :)
  10. H

    P0300, P0152

    I don't have experience swapping o2 sensors. You fellas think these ready to be changed? I'd say so. I pulled these out to swap their location hoping I would receive a different CEL code.
  11. H

    How reliable is the 545rfe?

    I have 318,000 miles on my 08. I don't know if it is original but as far as I can tell, its fine. I do have a drain back issue but a filter change will fix that.
  12. H

    Bad PCM? I'm at a loss...

    I have a problem with my truck, I found your post and it sounds like maybe it might help me. My check engine light came on and it was something about catalytic convertor or a sensor. Now today I am getting a flashing check engine light and a p0300. The truck seems to idle fine and when coasting...
  13. H

    Locking Lug Nut Key

    Good luck! I just went through this. Take a picture and maybe someone can identify it.
  14. H

    What did you do to your Gen3 today?

    Replaced upperbank spark plugs and coil pack boots. Coated the threads in anti-seize and dielectric grease to the porcelain. Every single one of the boots (but one) broke during this so I am glad I had already bought the boots before hand. Not all of the damn spark plug socket would fit in...
  15. H

    Mileage on your 3rd Gen.?

    08 Dodge Ram 1500 4.7 QuadCab 316,000
  16. H

    CB radio install ideas

    I was hoping to do something like this. I have seen double din bezels that are custom and there is even a navigation bezel for the truck but I don't have the money to fool around like this.
  17. H

    flashing MIL

    I was able to pull a cylinder two misfire DTC today. It is most likely because I broke the coil pack boot that sits over the plug. I have 8 boots on order, plus plug wires.
  18. H

    flashing MIL

    I plugged in and there are no stored codes. I have been scanning the 10K page book for situations for which that light flashes but I haven't found it yet. I have searched this forum and other sources for an answer but there is a wide range of answers. I am considering calling the dealer...
  19. H

    06 Ram 1500 2WD -Wheel bearings

    Might need to give a dealer a call. I just replaced a nosy wheel bearing and it wasn't all that difficult.
  20. H

    Which leveling kit?

    I googled it.
  21. H

    Which leveling kit?

    What is leveling?
  22. H

    Gas pump nozzle doesn't auto disengage

    It happened again. Was filling the truck up when gas spilled over. I had the pump nozzle in the tank opening and the lock engaged so I didn't have to hold it. Now, on every single other vehicle I have ever filled up, this wasn't a problem. Once the fuel rose to the level it usually would trip...
  23. H

    Water Cooler

    I found the 10,000 page book for it. Wow. This is what I found for the 4.7 in the book. There is another entry under EXPORT, pictured below tho it doesn't list upper/lower banks which is what mine has. another entry about the spark plugs for the 4.7
  24. H

    What did you do to your Gen3 today?

    Had a noisy wheel bearing so I swapped it out.
  25. H

    Water Cooler

    Does anyone else have the Haynes 30042 book? Page 1-3 says RC12MCC4 for the 4.7 spark plug at .040. Last night I was changing the plugs and noticed there are 16 plugs, not 8. While I was doing that I checked in the owners book and seen that there are two recommended plugs, one for upper and...

Latest posts

Staff online

Members online

... and 28 more.
Total: 1,285 (members: 78, guests: 1,207)
Robots: 1,304

Forum statistics

Threads
195,396
Posts
2,869,708
Members
156,061
Latest member
DirtyDan96

Share this page

Top