For chasing out existing threads pretty much any brand will do but to actually make new threads u need to buy high speed steel (marked hs or hss) and use the right bit not one that’s close to expect any tool life. The rest are only for thread chasing or fishing weights. It’s also a good idea to...
Couple pics of engine out and lift bracket I made to haul it out. Coil spring towers and frame were getting pretty scaly near the mounts so cleaned them up and repainted while I had good access.
i have a2007 2500 4x4 quad cab with a5.7 hemi. While vacuum priming an irrigation pump the safety failed resulting in swamp water getting sucked into the intake and hydro locking the engine resulting in a rod coming thru the block. Been looking at used motors and they r to pricey for what u get...
If it’s leaking externally as said clean and dry any wet areas then pressurize the system or run the engine to pressurize it and see where it’s coming from. Is it wet near the water pump thermostat heater core lines etc
Did u pull all the spark plugs?u could still be fighting compression. With the oil pan off u might be able to unbolt the connecting rods from the crank
Been using knowledge base here for a couple years for my2007 ram 2500 4x4 quad cab with 5.7 hemi bought new and rode hard since. Can’t say enuff how helpful it’s been here. Truck had the sno chief stickers (had those removed b4 I took it home)and dealer installed mm2 plow. Trucks a daily driver...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.