Search results
-
L
2018 Uconnect 4c UAS Update Files
Sorry about the delay… haven’t been on the forum for a long while but back in business now and messaged cfirecracker.- Lurker55
- Post #7
- Forum: Other Vehicle Discussion
-
L
Washer Fluid Level Low Warning
It’s the rain-x. The same stuff that in it that makes the water bead and blow off also coats the 2 prong sensor and causes this issue… you’ll have to wait till the fluid is low or out, and pull the sensor out (or when full have all the washer fluid spill out) and clean the sensor prongs, by...- Lurker55
- Post #24
- Forum: General Discussions
-
L
Question..small problem with 8.4
So our trucks actually stay on for approximately 10 mins after the engine and leaving the car/truck. Honestly don’t know what exactly it’s doing but it does. A full power cycle is consider after the truck sits for 10 mins. That is when you get the full reboot, unless you pull the radio fuse...- Lurker55
- Post #4
- Forum: Audio & Electronics
-
L
Additional UAQ/UAS Update Files 28.3/30.24/34.2
I can usually find any file that you need however I am limited by searching by VIN… can you PM my the VIN number? -
L
Pentastar vs Hemi, which should you choose?
I work here at the plant that builds the 6.2L red eye challengers and chargers… god these cars are a beautiful dream. I’ve driven them. One thing I can say for sure is… if I had that power under my foot, how would I not use it? Doesn’t matter what the blurred signs of the pump prices say as I...- Lurker55
- Post #115
- Forum: General Discussions
-
L
need a link to a uas 21.9 radio update file
If you can provide me the VIN in a private message (don't think we should post VIN in public) I can get you the Update files you need.- Lurker55
- Post #5
- Forum: Audio & Electronics
-
L
Additional UAQ/UAS Update Files 28.3/30.24/34.2
Can you private message me with the VIN number for the UAS radio? If you can I can get you the UAS 39.6 update file... -
L
Pentastar vs Hemi, which should you choose?
Personally… I have a V6 with 3.55 rear axle. And due to a car accident I got to spend time with a 5.7 hemi for 3 months while waiting for repairs. In my opinion, and for the most part my V6 is a commuter truck with 4500lbs towing 6-9 times a year. The V6 is great. Especially with the...- Lurker55
- Post #113
- Forum: General Discussions
-
L
I found a way to receive your own PIN CODE without the dealer :)
Guess this depends on the dealer? In Orangeville my dealer gave me the codes for free… though they took a long while even figuring out what exactly I was asking for. Guess the service advisors don’t know what the mechanics know.- Lurker55
- Post #134
- Forum: 4th Gen DIY
-
L
Firmware update for my UAS radio?
I believe the hotspot connectivity is built into the radio, using the radio/GPS antenna. So take advantage of it, but I think it isn’t tied to the Sirius guardian subscription or anything either. So enjoy it!- Lurker55
- Post #10
- Forum: 4th Gen DIY
-
L
How To: Install a 2018 4C (UAQ/UAS) Radio in 2013 - 2017 RAM
At the time I wasn’t able to get the adapter wire harness from Mpgrimm2 but had all the information available to me to splice into the harness in the solder my own connections to create a new connector for the compass USB hub. You guys rock!- Lurker55
- Post #3,425
- Forum: 4th Gen DIY
-
L
How To: Install a 2018 4C (UAQ/UAS) Radio in 2013 - 2017 RAM
I was successfully able to Transplant a 2018 UCQ 8.4 screen over to a 2015 Ram! And luckily enough not a single issue.- Lurker55
- Post #3,424
- Forum: 4th Gen DIY
-
L
How To: Install a 2018 4C (UAQ/UAS) Radio in 2013 - 2017 RAM
His has been the best forum for getting the upgrade done. Sooo much information and great work. Thank you so much Mpgrimm2 and everyone for all the help you’ve all contributed!- Lurker55
- Post #3,423
- Forum: 4th Gen DIY
-
L
Additional UAQ/UAS Update Files 28.3/30.24/34.2
Hey guys… I work at Chrysler and can get access to any and all uconnect update files that you may need. PM me if your looking to find anything. I don’t want to go nuts with this cause I’m sure I’m violating some sort of policy at Chrysler but I just want to pay back the help this forum has...
