Finally! Green connector pin 1 (red wire circuit A990) is fused with F80 10 Amp and it goes to the Module Compass. Is it wise to wire the power to the map lights to the power for the compass module?
Yes thanks, I'm familiar with that connector (Inline Headliner LP/IT 68057297AA).
Unfortunately no YE/BU map/reading light wire installed. That was my original problem. So I think my next best option is to use the Red fused wire in that connector pin 1 (circuit A990).
Before I start...
Thank you,
I found the Inline-Body/Chassis Connector underneath, that's not a practical solution.
I cannot locate the Inline-Body/Headliner Connector anywhere under the dash. The only two wires that go into my headliner are the center done light YE/VT and ground. Is it possible that since I...
I am planning to do the same mod, add the overhead console to my 2017 RAM 1500 Tradesman. I have the exact problem. My connector wires look identical. Where is the M27 YE/BU Reading Lamps wire? How was this solved?
Thanks Mpgrimm2, after looking through the documentation I can match a wire to a circuit and have located some other wires that may be useful later. I've got the drivers side green Inline -headliner LT/IP connector and its wire identified.
I have searched in my truck and can not seem to...
I've read through this entire post and I'm ready to add a console and rear passenger overhead light.
I've identified the green connector pin #11 Yellow/Violet as the overhead courtesy wire, but which pin is the 12v map wire? Also what are the other wires for?
Does anyone have a pinout/ID for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.