I’m pretty sure a longer oil filter would work for the 5.7, has anyone found a better choice with more filter media. Pretty bad when a 4 cyl has more than double the media. I am using a Wix 57060xp
Was tired of the stock springs sagging so easily and screwing up the direction of the blinding LEDs .I went w the 70%+ general springs all I was lacking was better support for the rear whil working on the 4 post.Ram in front of building is before spring job
Fixed a lot of extra with the approved quote by taking it to a local guy I washed and waxed with turtle wax carnuba and did the inside It was com covered in dents
I did the D1sc kit for my 19 ram tradesmen and have been waiting for my vette shop to install the headers and duals,but this new setup for monitoring pretty much everything sounded good enough that they ordered one for the ram and one for the z06
Wanted a way to store all the large shop tools so I could lift them up when i wasn’t using them. After I added it all up I realized I needed a pretty big one,so I got another lift coming on the 12th that the truck can fit under too. So I ordered a Hd9 xw that has 82”clearance and rolled my 10 yr...
I wouldn’t call this a how to,but just wanted to show my appreciation for the end result since I drove 200 miles on the interstate and smaller back roads last night so I can really say that removing the grill again was worth it,don’t want to make it a habit because it’s plastic snaps are crap.I...
After pictures and a discussion about what filter to get to replace the Procharger kit filter they sent me one with two 1/2 in holes instead of one in the center. Got the right one and was told to keep the other. Nice to have 2 ready to go with all the dirt roads here.
Because I have an account with amsoil I get their seasonal magazine,the article that I read in the fall issue was about Paul Jordan’s 408 molar drag engine that said he uses a wix oil filter as the primary and a amsoil oil filter as the secondary.I won’t go into the whole article that of course...
What I want to do with my ram tradesman S/C hemi is eliminate the cats and crossover possibly in the transfer output shaft area since the gas tank blocks off that side ,with a cooperative shop I have,they looked at it when it was elevated on the Dyno and said something could be done.any input...
I finally got the garage doors done with help from technical support who designed the 612 horizontals so they’ll clear the hood of the truck and I can park underneath of it now
I have a 19 classic work truck build date 5/19.I told my shop I wanted to boost my truck but without the usual headers and loud exhaust that will only aggravate my other half. Should of been easy given the amount of money they put into advertising at ram owners,but I found out I’m obviously the...
Just finished installing the third set of no drill mud flaps from Weathertech.Other then the fact that they couldn’t grasp the fact that my truck is a 19 1500 classic 2 door 8 ‘bed what really got me is the gap they decided was ok after removing the factory trim at the rear.The fronts were a...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.