Search results

  1. burner71

    hemifever tuning advise

    Ive used Hemifever a few times. When I installed a 6.4 cam he had me a good tune that ran awesome. He later made adjustments when I did head work and valve back cuts. Truck runs great.
  2. burner71

    Need Help with an Oil Leak on a 2018 Ram 3.6L!

    Places changing your oil have a bad habbit of over tightening the filter and cracking the housing.
  3. burner71

    6.4 no crank

    If it's intermittent try this. Go get a battery cable at the store and run it from the negative post to a bolt on your alternator frame. If it never happens again then you had a bad ground somewhere.
  4. burner71

    5.7 cam swap info

    that is the correct springs, you do not need to shim.
  5. burner71

    5.7 cam swap info

    The 6.4 cam is a nice upgrade in power especially with a little valve work. You will need the mopar performance springs or equivalent. Also, even if you are deleting MDS make sure you still buy the MDS lifters. I made that mistake and flattened a lobe at 36k miles.
  6. burner71

    i probably screwed up my timing

    https://www.mopardiy.com
  7. burner71

    noise ...

    Sounds like a bad pully bearing on the belt honestly.
  8. burner71

    update of 5.7 engine rebuild

    The milky oil could just be all the assembly lube mixing. The metal is worrisome though.
  9. burner71

    Possible starter issue.

    so this plagued me for littery years. I posted on here many times and replaced the starter 2 times, ignition etc, still would do it. Then one day I ran a wire from the bolt on my alternator mount to the negative on my battery post. Never clicked again. It's a bad ground somewhere.
  10. burner71

    Dead 2500

    just take the 2 screws out of the panel under the steering wheel and pull it off. Then unscrew the key ignition and unplug it. Open it with the side tabs and spray it with electrical cleaner and run a swab around it. Put it all back together and back in and it should be good.
  11. burner71

    5.7 & 6.4 Valve Springs

    Yep 2500 6.4's have it 2500 5.7's do not
  12. burner71

    Fuel Pump?

    No codes Shop called and said they checked all relays and fuses, all good. Pump is just dribbling fuel to the rail, pump is shot. 180 bucks to install plus part cost. Not bad
  13. burner71

    5.7 & 6.4 Valve Springs

    If you install the mopar performance springs they will be good for the extra lift of the cam and do not need any shims.
  14. burner71

    Fuel Pump?

    On the way to work this morning I stopped and filled up the went on to work about a mile away. At lunch today I got on the highway and headed for Home Depot. About 5 miles into the drive, i started losing power, then it would come back again, each time worse and worse. I was able to exit into a...
  15. burner71

    runs like ****

    When you accelerate does it shake and stumble and throw the misfire? If so, then sad to say lifters or cam
  16. burner71

    Resonator delete

    I got rid of mine and swapped my magnaflo for a super 44, it sounds great and super aggressive
  17. burner71

    Flashing cel under hard acceleration

    Mine did the same thing when I wiped the cam. Only did it when i accelerated hard
  18. burner71

    Motor shut down

    Sounds like the WIN module is going out.
  19. burner71

    Hard start problem. New OEM fuel pump and injectors didn’t fix it. HELP!!!

    if you turn the key to ON and hear the fuel pump and do that about 3 times, does it start fine?
  20. burner71

    Lifters keep failing in "rebuilt" engine! ADVICE?

    I don't know that I am hearing anything completely out of the norm in those last videos. Sounds like lots of injector clicking and mechanical noise. Are you getting misfire codes?
  21. burner71

    Will the 6.4 cam work in a 2012 5.7

    215/221 @ .050" .353"/.333" lobe lift .574"/.541" valve lift 121 LSA 108 ICL yes it works see above
  22. burner71

    Will the 6.4 cam work in a 2012 5.7

    It works and it does add noticeable power, especially with a bit of valve work. I have a 2012 2500 and I did it. You will need the mopar performance springs for the extra lift. You will also need it tuned. It will run on the stock tune but not that great. Get it tuned by Hemifever and it will...
  23. burner71

    66RFE issues

    Yes Sonnax. I definitely have a 66RFE in my 5.7 Its actually the second one. The first blew out a few years back. 2012 was the first year the HD gasser got the 66RFE. "The 2012 Ram 2500 Heavy Duty pickup also gets a new six-speed automatic transmission, called the 66RFE. It replaces the...
  24. burner71

    66RFE issues

    I have the 2012 2500 5.7 with the 66RFE Mine did something similar and I had the upgraded valve body and solenoid installed. Been good since.
  25. burner71

    5.7 based 392 hemi swap into 2012 ram 1500

    Not necessarily the mds that caused the tick. I have a 2500 without mds and Ive had it twice over the life of my truck.
Top