Search results

  1. K

    Whats this hole for?

    Building new engine. Whats this hole for? Drivers side, rear. Its not drilled out.
  2. K

    Dorman 615-523

    So I just ripped off and threw in the trash my new Dorman Intake. Im sick and tired of oil overflowing everywhere whenever I put oil(in a funnel) in.It flows out the funnel, out the filler neck and, to add insult to injury, burps oil out after you've cleaned up the previous mess.So Im installing...
  3. K

    P2172

    Truck stalled. Would turn over but, not start.Would run when really putting the gas too it but nasty. So I stopped. Only code was P2172.P2172 Throttle Actuator Control System - Sudden High Air Flow Detected I thought and hoped it was a cracked manifold. Nope. Broken valve spring on number...
  4. K

    Carter P76259M Install

    Ripped my bed off and installed new fuel pump. Tank was clean. Carter P76259M. I have a 26 gallon tank. It takes my fuel gauge a good ten minutes to register any gas I put in it. Kinda disappointing after all the work. Bought on Amazon, return period ended a week ago. Calling Carter to see if...
  5. K

    Power Steering Pump 2004

    Will a newer Mopar ZF pump bolt on my 2004 5.7? Im getting ready to have to replace mine again. This will be number 3 from NAPA since Oct 2020. Yes, I'm using ATF+4. And I flush everything upon installation. New rack and pinion. Pumps are new not remanufactured.
  6. K

    52079789AB

    Any of these is stock? I know they're discontinued.
  7. K

    Ac condenser fan

    I have a 2004 ram 5.7. Is the AC condenser fan supposed to be running if the ac isnt on? I noticed today while I had defrost on, my condenser fan was on. The AC button was not on. I just replaced the fan motor 6 months ago.I thought it was only supposed to be on with the ac button pushed on.
  8. K

    Drivers side power door lock dying

    It all started with a thunk! when unlocking. Now its a whirlll-jolt! Wake up! I ordered a new Mopar one. I heard the after markets dont last too long and arent so quiet.
  9. K

    Stalling at red lights and Stop signs

    2004 5.7. 210K miles. I have changed crank and cam position sensor. I have cleaned the throttle body.I changed the map sensor. I changed the egr valve with a Mopar one.I changed the pcv valve with a mopar one. I just pulled the intake and replaced the gaskets.Yes, it needed it.Truck running...
  10. K

    A/C PRESSURE TRANSDUCER

    Well, when changing out my spark plugs, my socket wrench slipped and my elbow hit this. Snap. Do I have to evacuate the system to replace it?
  11. K

    Anybody know what this plug is for?

    Its the square plug with two wires. It sets under the radio and behind the AC controller.
  12. K

    Elgin Industries

    Anyone use Elgin Industries cam/ lifters in a 5.7? And, if so, what are your experiences?

Latest posts

Staff online

Members online

... and 7 more.
Total: 1,288 (members: 57, guests: 1,231)
Robots: 1,712

Forum statistics

Threads
195,480
Posts
2,870,839
Members
156,199
Latest member
Neilr5515

Share this page

Top