Oliver Closehauf
Senior Member
- Joined
- Nov 21, 2020
- Posts
- 718
- Reaction score
- 458
- Location
- Cincinnati
- Ram Year
- 2005 Laramie
- Engine
- Cummins 5.9
Check out this video at the 5:20 mark. This guy uses a special press tool to install this hub/bearing combo. I'm just looking for that collar he's using or something like it. I've seen separators, but have not seen anything like this designed to be used as or in a press. I'm pretty sure the reason I'm replacing hubs is they used the hub to press in the bearing when they were installed a few years ago. If you know where to get this let me know.
I know this is not a Ram, but this is the garage section, so I think it's relevant here.
I know this is not a Ram, but this is the garage section, so I think it's relevant here.
Last edited: