Quick LED resistor question

[S.falcon]

Which wires do I splice into with the resistor? I have 2 white with green (outside wire and middle) and a black (outside wire) these LEDs have given me so many problems Im abou to scrap them altogether!

 

[S.falcon]

That's for my rears.. Green/white for both wires.. The front has a green/white and a blue/white, need to put resistors in both

 

[S.falcon]

Quick update.. Figured out which wires were which, wired in the 6ohm 50watt resistors and still have hyper flash? I must have wired them wrong I guess

 

[BlackedOutHemi]

Did you do the right wires? The resistor needs to attach to the ground of the light, and then the positive wire of the turn signal. From a post a while back, I believe Blackout11 said the wires would be the outside ones.

 

[blackout11]

First off you only need to do the rears and if the plug is in your hand youll want to tap into the 2 out side wires leaving the middle wire alone the resistor is just a loop so try that and that should fix your prob

 

[scott2488]

I found out with my tails, you have to push them in all the way or you get hyper flash and light out issues

 

[S.falcon]

Thanks guys going to give it another shot, probably wired them wrong

 

[S.falcon]

So put them in on my taillights.. As soon as I hooked up the resistor it shorts the bulb and it goes out.. Take the resistor off, light works... Tried 3 different resistors and all the same thing.. Didn't even bother trying the front switchbacks, just too frustrated... So back to v-LEDs everything goes tomorrow along with a phone call and email to let them know how completely disappointed with their service and products I am?. But thanks to you guys for all your help