drock1106
Junior Member
2013 RAM Laramie Longhorn with MTC HVAC. I have three blend / mode door actuators that have been connected while not installed so they have been rotated to some unknown position. Can anyone help me know how to set the actuators and how to set the MTC control panel so that they are both in sync when I install them?
I am new here and would really appreciate any help. I purchased a 14000 page pdf service manual but could not find the answer to this question.
I am new here and would really appreciate any help. I purchased a 14000 page pdf service manual but could not find the answer to this question.
Last edited: