Upper glove box

Disclaimer: Links on this page pointing to Amazon, eBay and other sites may include affiliate code. If you click them and make a purchase, we may earn a small commission.

tex68w

Member
Joined
May 10, 2021
Posts
58
Reaction score
14
Location
Texas
Ram Year
2021
Engine
6.7L CTD
Looking to add the upper glove box to a 2021 3500. I have P/N 6YK08TX7AA for the glovebox itself, but is anything else needed? How do you go about removing the current parts in order to install it? I saw videos on adding it to the older 4th Gen trucks but I haven't come across any for the 2019+ 5th Gen.
 

tron67j

Senior Member
Joined
Oct 14, 2019
Posts
2,794
Reaction score
2,827
Location
Maryland
Ram Year
2018
Engine
6.4 Hemi
I did 4th Gen, so can't exactly relate bit would imagine it is about the same. You can reach out to Benny at allmoparparts, he will make sure you have the correct part number. It comes as a kit with the new box, door and light. The connector for the light on the 4th gen was taped up near where the new light is, so if you take current cubby out and poke around, you should see a green (I think) connector. I would follow 4th gen for removal and see how similar it is, I also don't see it for 5th gen yet in a video. Good luck.
 
OP
OP
T

tex68w

Member
Joined
May 10, 2021
Posts
58
Reaction score
14
Location
Texas
Ram Year
2021
Engine
6.7L CTD
Yea I watched both of those for the 4th Gen. I'll try the same process for the 5th Gen and see how it goes.
 

GTyankee

Senior Member
Supporting Member
Military
Joined
Nov 2, 2020
Posts
10,059
Reaction score
12,600
Location
El Cajon Calif. 92021
Ram Year
2016
Engine
3.0 ecodiesel
I think any changes will be minor

Good Luck with your installation
 
Top