Recent content by malonerory

  1. M

    Toyo AT3 vs Falken Wildpeak AT3W

    I run Toyo ATIII 325/65/18 on a 2500 Diesel, they have around 15k on them and I have zero complaints. They are not at all loud on the road and for being on a diesel they grip decently in snow and ice. You cannot go wrong with either brand, they are both great manufacturers.
  2. M

    Regen Regen Regen, Excessive Regen. Need help

    You would think. Service advisor at the dealer is very cool, he told me he would reach out to the star department to get the 3 next steps so it is not sitting. I know I cant be the only one having this problem
  3. M

    Regen Regen Regen, Excessive Regen. Need help

    Diesel fuel, different stations all over northern Utah. Forgot to mention the PCM/ECM/TCM/BCM were updated for the new CP3. Two visits ago the updated flash was removed to try to fix the problem
  4. M

    Regen Regen Regen, Excessive Regen. Need help

    I have a 2019 Ram with a 6.7. In January of this year CP4 went out, 1-month at the dealer before they replaced the entire fuel system and put in a cp3. Since this work the truck is performing a regen every 50-100 miles. I can hear the difference in the motor when it regens and the DPF monitor...
    • malonerory
    • Thread
    • 5th gen cp3 swaps dealership dpf delete egr valve fuel economy recalls regen
    • Replies: 18
    • Forum: General Discussions
  5. M

    throttle response

    Pedal Commander for sure. I have a 20 Ram 2500 Diesel and it makes a huge difference. Never had a limp mode incident. You might get a check engine light if you unplug the throttle while the ECM is powered on but it clears after a couple of starts. I unplugged the batteries and installed it...
  6. M

    Def Regeneration Frequency

    Similar issue here with the same truck. No codes, however the dealer in Utah re-updated the ECM software and my truck registered a code for a stuck closed EGR (which was replaced.) My problem did not start until my CP4 went out and was replaced with a CP3 by the dealer under warranty/recall...
  7. M

    leveling kits and handling

    The cheaper you go the worse it's going to be. As previously stated, pucks bind and put extra compression on your stock springs causing a horrible front end ride. It will also cause your camber to be out of alignment. You have an older trucks so there should be some A-arm kits available if money...
  8. M

    5th Gen 2019+ Foglight Add-on harness

    I purchased the wiring kit from Mike. I have to commend him, great craftsmanship and quality. All his Mopar zip ties lined up perfectly with holes in the frame. I choose to install Baja Design fog lights, the Baja Design lights come with adapters to plug into the OEM connector Mike uses...
  9. M

    Suspension popping

    Same truck. Mine does this too. I have had it at the dealer twice and each time they find nothing. It's a distinct "pop" sound from the front end, its not dull, I am pretty sure it is a bushing as mine does it more when its below freezing. I bought some grease gun needles just need time to...
  10. M

    Thuren leveling kit.

    No sway bar during my install. That is next on the list. I forgot to mention that I also bought a Fox IFP steering stabilizer. When I received the shock I opening the fill port on the shock to make sure it had zero nitrogen in it.
  11. M

    diesel or hemi?

    So I have two different types of Ram 2500's. The truck I use for work is a 2018 2500 with a 5.7 Hemi. Its a regular cab long bed 2wd, I average around 10 mpg. Weekend truck is a 2020 2500 Diesel crew cab short bed 4x4, my average is currently at 17 mpg Both of these trucks get the job done...
  12. M

    In shock and a migrane!!

    My work truck is a 2018 2500 5.7 Ram regular cab long bed with 35's. I have never seen anything over 15 mpg. This was achieved on a 50 mile unloaded trip at 70 on the freeway. Average right now on the truck is 10.2. I use it for work so I drive in mixed conditions. Stock tires were on the...
  13. M

    Thuren leveling kit.

    I have the 2" Thuren kit with Fox Shocks and I added the rear shocks. Truck is perfectly level at 2". Ride quality after the install is amazing. In fact, the ride quality was so much better my wife even noticed. If you do it yourself (which I did) you'll need to make sure you have two jack...
  14. M

    Selling truck, leave modified or return to stock?

    Take it to the dealer and see what they say in regards to trade in value. Let them deal with it if you do not want to. There is nothing wrong with that. Let them inspect the vehicle and answer any questions they have.
  15. M

    New, undelivered 2500 has keys stolen on train

    It honestly sounds like a dealer/manufacture problem to me. You have not taken possession of the vehicle therefore their problem. I understand them informing you but his answer should have been "delivery will be a bit delayed as we have to program some new keys." Remember, they (dealers) have...
See more

Latest posts

Staff online

Members online

... and 1 more.
Total: 1,406 (members: 51, guests: 1,355)
Robots: 1,464

Forum statistics

Threads
196,407
Posts
2,881,650
Members
157,726
Latest member
daddynmomma12

Share this page

Top