-
-
rzr6-4 replied to the thread Front Axle Adjustment?.The left-to-right spacing is determined by the track bar, but it changes dynamically with your ride height. Mine was in the center but... -
rzr6-4 replied to the thread Towing Question.Sticker isn't clear as in you don't understand what it means? Tow rating will vary a lot based on what options your truck had equipped...
-
rzr6-4 replied to the thread Took a look inside my hemi.High idle time - check Been overheated - check -----More than once - check Been run with low oil - check 200,000 + miles - check...
-
rzr6-4 replied to the thread My Dad has an awesome set of tools, I can fix it..Between totaling my sierra in a front end wreck, hitting a snow bank in my Ram at 30 mph that turned out to be a wall of packed ice, and...
-
So little time, so few posts, so much bad information. Amazing.
-
rzr6-4 replied to the thread Rotor and pad kit recommendations?.https://parts.allmoparparts.com/brake-rotors/2009-dodge-ram-2500?brandType=oem This is the site I use for OEM, just make sure to put in...
-
rzr6-4 replied to the thread Rotor and pad kit recommendations?.Performance brakes tend to be more noisy, not as smooth and wear quicker. If performance is the goal then you will have to keep those...
-
rzr6-4 replied to the thread My Dad has an awesome set of tools, I can fix it..Frame? I just float around on 1000lbs of rust. DMV couldn't care less as long as they get my $$$.
-
rzr6-4 replied to the thread My Dad has an awesome set of tools, I can fix it..My old Sierra is pretty much the same scenario. Totaled on front end but otherwise clean so I bought it back, slowly rebuilt it and got...
-
rzr6-4 replied to the thread Flooring ideas?.Only if its the legit spray gun kind. The stuff in a rattle can is garbage. Flex seal or equivalent? Not 100% sure how tough it is but...
-
rzr6-4 replied to the thread 4th Gen 0 to 60 Times with Cam Swap.Mine is a 2500 but stock the 0-60 is measured in business days. 5.4 Seems pretty good to me. Are you including your rollout time...
-
rzr6-4 replied to the thread bilstein 5100 shocks on Stock 2500 4x4.Correct me if I'm wrong but isn't the height solely determined by the coil spring? If you put taller/shorter springs in you may need to...
-
rzr6-4 replied to the thread Side exit exhaust / new muffler.That makes me think.....I was going to cut it after the Y so it would be a single all the way back, but I could cut out the Y...
-
-
Loading…
-
Loading…
