PCA4208
Senior Member
- Joined
- Nov 27, 2012
- Posts
- 2,658
- Reaction score
- 580
- Location
- Albuquerque, New Mexico
- Ram Year
- 2017
- Engine
- Hemi 5.7
Finally was warm enough to install my bass knob today
This is it
And this is where I wanted it
First I had to remove the dash by unscrewing this screw, then just pull out the dash vary carefully
Then I ran the wire from my amp, and just followed the remote wire up into the dash, then I drilled a small hole in the little cubby and ran the wire in it.
And lastly I screwed in the little mounting tab to the top of the cubby. I have no picture of this because it was the most difficult part of the install. Then just plug in the knob, and slide it onto the mounting bracket.
And you're done! Took me about 30 minutes
I'll be posting a video of it in a bit.
This is it
And this is where I wanted it
First I had to remove the dash by unscrewing this screw, then just pull out the dash vary carefully
Then I ran the wire from my amp, and just followed the remote wire up into the dash, then I drilled a small hole in the little cubby and ran the wire in it.
And lastly I screwed in the little mounting tab to the top of the cubby. I have no picture of this because it was the most difficult part of the install. Then just plug in the knob, and slide it onto the mounting bracket.
And you're done! Took me about 30 minutes
I'll be posting a video of it in a bit.
