Recent content by 99Ram318

  1. 9

    Rear power door lock issue

    Can't tell you how many times I have done that - just step back and take a second look and figure it out.... or a second beer!!1 ;)
  2. 9

    Dodge Ram 1500 mega cab?

    I had some Marvel's setting around. I use it in my 1977 C10 before I change the oil (about 100 miles before the change)..... It has 360k on the 350 motor!! still doesn't smoke or anything..... Anyway, I had a full bottle laying around so I dumped it in the crankcase and it stopped the clatter...
  3. 9

    Dodge Ram 1500 mega cab?

    I found this thread and have the '06 Mega Cab 1500 5.7 Hemi. Lately, if the truck sits for a day or two, it has a bad lifter-tap (not the tic - have heard it)... I have been running 5-20 Mobil full syn with either a Mobil or Purolator filter (NEVER Fram). It takes about 4-5 minutes to warm...
  4. 9

    2006 5.7 Hemi P0032 Code

    Received PCM today from All Computer Resources - everything cleared.
  5. 9

    2006 5.7 Hemi P0032 Code

    OH - and BTW - the lead going to the Gas Pedal Position Sensor is correct.... There is a splice behind the motor for 1/1 and 2/1 banks and they work in conjunction with the gas pedal with Air Temp sensor and gas pedal along with timing and other things....
  6. 9

    2006 5.7 Hemi P0032 Code

    Yep, I had to go to dealer - 2006 Mega Cab / 5.7 Hemi has a totally different wiring diagram than every other vehicle made. This vehicle has been a headache every time something needs to be fixed. I learned early on, take the part with when I go to the parts store. Because of the 2500 frame...
  7. 9

    2006 5.7 Hemi P0032 Code

    Bad PCM....
  8. 9

    2006 5.7 Hemi P0032 Code

    Something I should probably bring to light - here in the past year or so (since last summer) I have been going through anti-freeze. No smoke, no water in oil and no oil in rad. This thing has sit since the last time I posted - Sunday and it was full because I filled it. I had to add at least a...
  9. 9

    2006 5.7 Hemi P0032 Code

    So - no shorts that I can find. If anybody has a link to the PCM pin-outs that would be great. I'm thinking before I rule the PCM being bad. I'm going to just rewire from plug to appropriate locations on the PCM plug(s) and ground. OK - have a tracer hooked up to BLK/LT Green and Brown/ Light...
  10. 9

    2006 5.7 Hemi P0032 Code

    BTW - tomorrow once the pipes are cool, going to meter out to see if there are any short between the male plug on the signal side and what the total resistance is between the ground and the #107 with a wire.
  11. 9

    2006 5.7 Hemi P0032 Code

    The white marks on the wires leading back to the motor is not much, I felt them they were minor rough, nothing major. Didn't see any exposed wiring. The old sensor I took out I tested again and had 4.3 ohms across the heater wires. Stuck.....
  12. 9

    2006 5.7 Hemi P0032 Code

    Ok, so there are two grounds on the fender wells, one on each side about 4-5" from the firewall near the hood, support cylinders. The one one the passenger side was fairly clean; driver-side was dirty. Cleaned them both up real good and scuffed them up. Replaced bank 1/1 with another new sensor...
  13. 9

    2006 5.7 Hemi P0032 Code

    Well - just one PCM - it shows two but that is the one for the Diesel.... so 31 is mine for the PCM. Tell you what, having a 2006 Mega Cab with the 5.7 has caused more issues ...... 1500 sitting on a 2500 frame... I have to take parts off and go to the parts store and argue with them.... Or...
  14. 9

    2006 5.7 Hemi P0032 Code

    10-4 - will check the G107 this afternoon. Is there any specific fuse I need to check? I don't see any on my fuse panel that shows O2 - although I do have two PCM fuses.
  15. 9

    2006 5.7 Hemi P0032 Code

    So - I have used 4 total sensors, switched them back and forth with each other, had them heat tested and meter tested at Oreilys. All test good. I am going to assume #107 is the pin on the PCM I need to check? The Chilton's book I bought is useless because it does not have a wiring harness for...
See more

Latest posts

Members online

Total: 1,465 (members: 43, guests: 1,422)
Robots: 1,606

Forum statistics

Threads
195,789
Posts
2,874,499
Members
156,719
Latest member
BigJon8112

Share this page

Top