Recent content by carrmann

  1. C

    2004 ram st installing power leather

    As the title says. Picked some leather dodge ram seats(power movement, manual back and lumbar), they fit perfect. However the wiring harness plugs in, but the wires dont match up in location, and the seat has 5 wires while my truck harness has 4 (the power seats also has the armrest with storage...
  2. C

    Cant 'fill er up

    the fill tube hose is mediocre. the vent tube is fine. i've tried holdin the pump all different ways to get it to work. that did nothing sadly. normally its the fillerneck/vent tube (its a single piece assembly) but this one is fine.
  3. C

    Cant 'fill er up

    Bought the truck about 4 ish weeks ago, first tank I filled it up no sweat. Since that tankful I have NOT been able to fill it up. The pump 'pops' after about .5 gals on average. It takes around 10 minutes or so to do 8 gallons. I borescoped the fill tube (no blockage, and the spring valve...
  4. C

    Over 200k miles, suggested oil?

    its a tapping type noise. im wondering if it is maybe piston slap?
  5. C

    Over 200k miles, suggested oil?

    No one has any input on the engine noise?
  6. C

    Over 200k miles, suggested oil?

    About to change the oil and get an alignment done (going to raise the front end about 1/2" as well before the alignment). Has 205k miles on it. No idea what is in it now for oil. Any suggestions on what I should put in? I live in Fl, so its never cold (below 30*). Just seafoamed the gas...
  7. C

    changed plugs, found stuff

    I'm planning on doing a seafoam treatment or 2 to it lol
  8. C

    changed plugs, found stuff

    https://m.summitracing.com/parts/cwa-53032531ae?seid=srese1&cm_mmc=pla-google-_-shopping-_-srese1-_-crown-automotive&gclid=Cj0KEQjwmv7JBRDXkMWW4_Tf8ZoBEiQA11B2fkv39cMaavvpDD8IxuBaoJrP3-XLixy-g_Attht7d8QaAgAi8P8HAQ That's the 03-04 hemi pcv.
  9. C

    changed plugs, found stuff

    Hopefully. its definitely running a lot better than when I got it. Not going with an oil catch can, had one on my trans am. Thanks for the 'advanced' tip. I was able to. had to significantly shrink the picture haha.
  10. C

    changed plugs, found stuff

    already looked at the belt (its mediocre, will probably buy one to have as a spare). plan on replacing the idler pulley (it makes a little noise). I will do that then. Dont like having that junk sucked into the motor at alllll. I dont mind a dirty tb, but what was in the intake manifold is what...
  11. C

    changed plugs, found stuff

    changed my plugs today. first of all, what a pain lol (the drives side back set). had 2 boots rip off inside the tube. Quite a few were barely more than hand tight, one plug WAS hand tight. Most looked fine. 6 on the drivers side did not. They had a orange/rust tint on the porcelain area by the...
  12. C

    weird random issues

    Where is the build date on these besides the drivers door?
  13. C

    weird random issues

    so its been eating water(thought it was a leak). think i saw water vapor/steam coming out the tailpipe today. also know it was pushing water out the overflow, it was down a half radiator in amount on my drive to/from work with some idling as well in my driveway while I checked temps with a...
  14. C

    Multiple random misfire

    thanks again. code changed. now it doesnt have p0300. has p0335 and p0340.
  15. C

    weird random issues

    Just rechecked the codes today (i cleared them the other day).. and now it has p0335 and p0340 (crankshaft pos a and camshaft pos a). but starts/runs fine. any ideas?
See more

Latest posts

Members online

... and 3 more.
Total: 1,259 (members: 53, guests: 1,206)
Robots: 1,808

Forum statistics

Threads
195,657
Posts
2,873,005
Members
156,507
Latest member
Pots31

Share this page

Top