Sorry Nuemie, I can hardly believe those heights with 990lb tongue weight. i had airlifts 1000's in my '13 with a 800lb tongue weight and wd hitch. still dropped the back by 2-3 inches at 35psi. quite bouncy on rough roads as well. On my '15 I spent the extra on the LL5000 Ultimate from airlift...
this is my problem. I have two sets of wheels (+18, +19 stockers) and they fit and looked ok until I added fender flares. now they look puny (33x12.5r20 m/t) so I'd like to move them out. a 1.25" will make them almonst -14 and -13 offset each. a 1.5 inch will make them about -20 offset. will rub...
also half ton rams are coil springs in the rear not leafs. air bags will stiffen up the ride and reduce squat but you cannot increase capacity anyway. I think mega cabs tow the as they weigh the most... depends on what you are doing with it I suppose
on my 2013 sport with 20" wheels, will a 275/65/20 fit without a leveling kit? there are not many decent tires in stock size. also will dodge be able to re calibrate the pcm for that size? I know that they are only 1" taller but 10ply is way better.
I've seen a tire shp here where I know the guys, putting 35x12.5x20 mudders on a raptor and the tire once mounted was 14 oz out on one spot. taking the tire off and spinning the rim only showed it was definitely the tire...BRAND ******* NEW $800 DOLLAR EACH TIRES!! wtf. just thought it...
moparpartsonline.com search trailer brake controller, the 2012 is different from the '13 adding the oe controller will make you WAY happier in the long run
the manual shift is actually only to limit what gear the transmission can reach, not a true tiptronic shifter. tow haul does not eliminate overdrive...you just have to drive faster to get into them. It does raise the shift points and It does allow for better transmission cooling as many...
under the driver footwell panel on the right are two plugs (gray) all wrapped up with foam/tape. non factory brake controllers require a pigtail adapter sold at rv shops, or you get the mopar one installed and still have trailer sway control and whatnot working through your computer
I live in Edson, Alberta...200km west of Edmonton, the parts guys her are ridiculously expensive. Any one know where I can get a catch can shipped from for a reasonable price? for a 2013 hemi 6spd ram 1500.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.