Would you please provide a part number for the bioteck that you referred to above?
I’ve used redline 5w-30 in my 3017, 1500, 5.7L, Ram for the last 50K miles. Had the tick since new. Redline virtually eliminated it.
I was down to my last 4 qts. of redline so on this last oil change...
As others have said……Wilton.
Im partial to the bullet vises myself because that’s what I used for 30+ years at work.
Looked for a used Wilton Bullet for years with no success and finally found this pre WW2 Colombian that need some serious TLC.
Ive been very happy with it.
Don‘t overlook a...
I’m going to go back and address the OP‘s original question.
If you’re serious about cables and will pay for quality as you said, check out these guys.
https://store.polarwire.com/jumper-cable-2ga-20-heavy-duty-all-copper/
@LouM I have these rails as well. I was lucky enough to find three more tie down brackets in a pick n’ pull junkyard.
Before I found those I was experimenting using tee nuts that are used on a mill or drill press table. If you’d like a couple of pics, let me know I’ve still got these out...
OP
I saw this idea awhile back and have not completely given up on adding this to my Ram
2” Angle iron, 1/2“ round stock, this would be simple to weld up yourself or Id think pretty cheap to have made by a local welder
I’ve used a Viair 400P with my Jeep for the last five years.
VIAIR 400P Portable Compressor https://www.amazon.com/dp/B000X9AXR8/ref=cm_sw_r_cp_tai_r4owCb90GC0M8
I bought mine slightly used off the board at work for $125
It’s used to take my 33s from 10psi to 26psi after running off-road...
Thank you sir! I’ll hold off until I see what you publish.
Two more questions please: Did you find the .550 width of the hook mounting slots to be the correct dimension?
Do the factory studs seem to press in correctly at the .550 width?
Thank you.
@kad can you please tell me how much your brackets differ from the drawing that Ken? posted earlier in the thread?
I have the angle and I’m about to start fabbing up a pair of brkts for my 2017.
If you plan to post your final version in this thread then I apologize for the question.
Thank...
JB1 if you are considering producing these I'd like more info, price, lead time etc. I've taken a screen shot of Ken's excellent design picture. My compliments to him for both the design and the generous sharing of info.
Once my garage cools off a bit I may have get to work with the bandsaw...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.